|06-11-2012 03:18 AM|
Gonna be repainting the dash in the near future so I'll put it back together right this time.
|06-11-2012 02:22 AM|
|98GunmetalTJ||I believe S3nt3nc3d and I covered how to remove the airbag panel. Several obvious visible screws once you remove the glove box. More visible screws once you pop off the vent panel across the top of the dash. The rest of the panel is riveted to a cross bar. To remove this crossbar, follow the link S3nt3nc3d provided and the suggestion I posted above - two 10mm nuts/bolts. One behind the speaker/air duct, the other can be reached by removing the center section (radio, A/C) of the dash.|
|06-10-2012 10:39 PM|
|Doublesnook||I am pulling all the panels out to paint and need to get the airbag panel out... I was wondering if anyone knew how to pull it out are there screws or just pull???!!!!!|
|06-10-2012 09:45 PM|
|Patrick H||You don't need to remove any of that to pull the dash out. Just the two nuts for the airbag right above/ behind the glove box.|
|06-10-2012 08:16 PM|
|Doublesnook||I got the bar off does anyone know how to get the airbag panel off?|
|06-10-2012 05:07 PM|
The pictures in the link that S3nt3nc3d provided show exactly where the nuts/bolts are.
Remove the speaker:
Unscrew the one screw holding the duct work in place and bend it out of the way with your fingers (it isn't needed). Deteach the ductwork and pull it out:
Should allow you to reach in easily and get a ratcheting box wrench or small socket in there:
|06-10-2012 04:56 PM|
|06-10-2012 04:45 PM|
It is a B*TCH...there's a thread on here somewhere with pics. I'll see if I can find it. You need monkey hands to get in there. 2 bolts.
Getting it back on is more difficult than taking it off...
|06-10-2012 03:54 PM|
Ok got the Bar off 10mm bolts perfect thanks.
Now does anyone know how to get the airbag plate off??? This would be a big big big help!!!! Thanks!!
|06-10-2012 03:35 PM|
|06-10-2012 03:34 PM|
2 10mm nuts on the inside .
Take the glove box out you'll fill them one on each side
|06-10-2012 03:33 PM|
|O_M_Jeep||if your talking about the grab bar on the passenger side there are lock-nuts on the back of it, it has studs that go through the dash, they are tough to get to if you dont have a good set of 1/4" drive tools|
|06-10-2012 03:29 PM|
Oh S**t bar off
Eying to remove dash. I need to get the bad off anyone know how?? Need help!!!!