|11-02-2014 12:54 PM|
|kdorko||My 2002 just contracted the Jeep Flu: thought that yellow TJ looked a bit sick when I parked next to it ! Anyway, in sheer and utter frustration I rattled the stick shift (OK, so I was really trying to rip the shift lever out and beat the dash with it) and suddenly it started. Most of what I'm seeing on this forum is automatics, but I will try the grounding strap to the tranny. Letcha know how it works out.|
|08-25-2014 11:17 AM|
Not sure if this is an old thread as I just joined today. But here it goes. My mother's jeep has had this Jeep Flu. This thing has pretty much never been taken to a Jeep dealership and has been abused more then my 3.8L Buick when no one has been watching. It has about 101k miles on it. Her starter has not started for her before. She has had multiple jumps from a supposed dead battery... There has been only ONE time that this has happened to me. Just one time! And that was in my driveway and my DMM read below 9.0 Volts if I can recall correctly. So, we replaced the battery due to how often it has been drained down to nothing.
She brought it to me yesterday to change the starter... Well, apparently on her model her starter is covered by a heat shield that I can not get off with out cutting it off and I have almost no wiggle room under there, even after buying 6 inch ramps. The Transfer shaft to the Front wheels is in my way... I almost successfully removed it but the last bolt was unreachable with my massive disarray of tools meant for older vehicles. I noticed that one of the 3 bolts that holds the starter in place is missing. I did find a little rusty something in there that I am not able to retrieve at the moment.
I am going to my school today with the Jeep with a scan tool in hand to diagnose it.
I will post my findings when I get back.
History of the Jeep: Neglect, and abuse. Been in 3 vehicular accidents. 1 involving another vehicle, the other 2 involving pedestrians. That I know about.
Sorry, I do not know much about part names.
We have a starter already ready to replace the old one. (BANG! Shooting from the hip... Not my diagnosis.. although I did agree that it could possibly be the starter from wear and tear when it was used for about 4 months as a food delivery vehicle.
Every time the vehicle is taken to me I am unable to Verify the Concern. Except that one time the battery was Very low on charge.
I will test y'all's idea of try to start it in Neutral if it does miraculously not start for me when I drive it home today...
If that works I shall perform the new grounds method mentioned here. It does sound very believable.
I will be sure to write here the results of my technical research.
|07-25-2014 10:46 PM|
|reif44||I have the same exact problem. I have a 2008 jk unlimited. I go to start the car and all i get when trying to start it, is a click. It didn't start 7 times 3 days ago, so i take it to the dealership and it starts everytime. I took video of it happening. If you go to my twitter page you can see the video (www.twitter.com/reif44) . The dealership refuses to do anything since it hasn't happened in front of them. I go on a long drive in a week and i'm trying to fix the problem before I leave.|
|03-16-2014 06:10 PM|
So my '08 Jeep Wrangler Unlimited began starting only when it felt like it. One day it would start with no issues and then the next time I would go to fire him up and nothing! The dash would light up and everything seemed normal, until I turned the key...click and nothing. Wiggling the shifter lever was all it took to get my Jeep to fire up again. Obviously the sensor in the transmission is acting up, but at least I know it's nothing like a bad starter or ignition.
So if your jeep starts one time and not the next, wiggle the shifter or shift from park to neutral and back......bang! Your jeep will fire up.
|10-30-2013 07:43 PM|
-Starter problems (neutral works replaced starter first waste of $)
-Remote entry and remote start does not work (neither key)
-When I lock door and open with key the horn sounds (like the alarm)
-Airbag light stays on (dealer said its clock spring, Some 2008 recalled in 2011)
I read where the electrical system runs through the clock spring.
Did you have all the above issues?
|07-30-2013 12:05 PM|
|07-22-2013 08:44 AM|
|07-19-2013 05:35 AM|
|Weecee||I've replaced battery as well. How hard and how long did it take to change out the switch?|
|07-18-2013 11:22 AM|
Could be, could be the battery too. But most likely is the other issues discussed. The charging system can be checked with a voltmeter.
|07-18-2013 11:09 AM|
|07-18-2013 10:40 AM|
|Mossman||I can only repeat what I said last year - install the grounding straps before you tear apart your tranny. As an update, since doing this over a year ago I have had no return of the problem.|
|07-18-2013 10:39 AM|
|07-18-2013 10:03 AM|
|07-17-2013 08:21 AM|
Replace SNS on Wrangler X 2008
Does anyone Know how to replace the SNS on an automatic transmission
|07-17-2013 05:55 AM|
I too am now a vitim of the Jeep flu. Intermitent starting. Mine is a 2008 auto wrangler. Usually takes 3 tries but when shifting out of park and back to park with the key on only does it once. Any new info on this? And if i do go to get the switch or sensor in the transmission replaced any ideas how much it'll cost?
|06-12-2012 10:29 PM|
If you are out of warrantee then that is the "free" method. If it starts to get intermittent you can try Park to Neutral then back to Park again - I had to do that a few times.
If you have the standard "click no start" problem then there aren't any codes thrown, and when it's not stuck it tends to fire right up, so it's hard to diagnose. I told my dealer about it and they said that based on my description they would just go ahead and replace the TRS (under warrantee), which fixed my problem.
|06-12-2012 10:06 PM|
Ps, neutral ALWAYS WORKS FOR ME
|06-12-2012 09:07 PM|
Mine is a 2010 with 6 speed manual; started acting up a while back not starting intermittently-- today, it would not crank at all, gave it a pull and bumped clutch- it fired right up. Still will not crank under its own power.
Tried jumping solonoid while holding key in start position and it fires right up. I think it will be hauled to dealer on friday. Whatever the outcome; I think there will be an emergency starting system installed after this.
|06-12-2012 08:15 PM|
I had the same problem. There seems to be two main reasons for the click-no-start issue (apart from a dying battery, that is). The first is a problem with the ignition key sensing module which can be affected by static discharge from the key. You can check this by waiting until the problem occurs, then pulling the IOD fuse, waiting 15 seconds and reinstalling. If this fixes the problem, you need a new CSM module (another clue that the CSM is at fault is if your remote-access door locks don't work when the engine won't start). This is a few hundred bucks.
If the CSM isn't at fault, the second main possible cause is with the transmission range sensor. If the condition is at all dependent on the position or if wiggling the auto shift lever while starting seems to help, then the TRS is erroneously locking out the ignition by signalling that the shift lever isn't in P or N, when it is. Fortunately fixing this usually doesn't require replacement of the sensor, which is an involved job. Rather the problem is with the sensor's ground, and as other have said you can install some redundant ground straps to solve the problem. Just take an 8 gauge or better wire from the engine block to the battery negative, and for good measure you can also run one to the alternator and to the transmission bell housing. When this is done, make sure to charge your battery. This seems to work for almost everyone.
After two weeks of a frustrating runaround (the dealer, bless its stupid heart, replaced the starter, a useless exercise), I stumbled upon the ground solution described on this and other forums. Problem has not recurred since.
|06-02-2012 12:41 PM|
|joe002||If he wants to try something a little more simple then he can try to run the good ground from the battery, to the body, to the engine, to the transmission. It may work - it has for some others.|
|06-02-2012 12:37 PM|
It's located inside the transmission under the valve body.
|06-02-2012 06:16 AM|
|keltastic1||Does anyone know where the TRS is located, my husband wants to replace it. I looked online, but can't find a Diagram.|
|06-02-2012 04:18 AM|
|odimodus||My old 08 (traded, but not cuz of problems) did that a few times. Unhook one of the leads off the battery and reconnect. The horn will honk once when battery is reconnected and the jeep always started right up after that. Seriously, worked every time for me and it's a simple fix, but it is a pain in the arse.|
|06-01-2012 04:53 PM|
|06-01-2012 03:58 PM|
|keltastic1||It happened to me just a few minutes ago. Thank you, putting it in N worked!|
|06-01-2012 02:55 PM|
|keltastic1||I'm having this same problem. I was thinking it may have something to do with the key, but my spare, which is just a plain key that's doesn't have the buttons did it to. I hope this solves our problem, because it not fun being stuck some were for 20 minutes or more till it decides to start.|
|05-31-2012 08:22 AM|
|pkmcd99||The infomous Jeep Flu. Affects all jeep models since the transmissions and ignitions got all fancy electrical gadgets. Good luck. Hopefully its just one sensor. Commanders have been plagued by similar issues which dealers have now snickered and called Jeep Flu because the problem acts like one sensor malfunction but turns out to be others such as temp sensors, theft lock issues from chipped key...etc|
|05-31-2012 08:09 AM|
|rgiand71||OK, It happened again , finally!!!! Got in the Jeep and turned the key and nothin... just click, click. all lights were on but no start!! so I tried it.. I just jiggled the shifter & turned the key and YES!!! it started... good to know that it worked. Now to tell the deal sometime & see what they will do about it..|
|05-26-2012 04:18 PM|
The “click no start” problem is well documented and has been around for a long time. If you have an automatic, and when you try to start it you hear a click and the engine doesn’t start, try shifting to Neutral and see if it starts. If it does you have the “classic” symptoms.
The problem is that your Transmission Range Sensor (like a fancy Neutral Safety Switch) is acting up. There are three solutions:
1. No cost (usually works): When it happens, shift to Neutral and start it up.
2. Low cost (may fix it): Make a new really good ground from your battery, to the body, to the engine, and then to the transmission. This solution has worked for some.
3. High cost (seems to fix the problem): Get a new Transmission Range Sensor installed. The TRS is inside of your transmission and requires a bit of work to replace it.
I had this problem and brought it to the Dealership. The told me that they tried the ground fix and it worked for many but some retuned as it didn’t totally fix it. They said when they replaced the TRS it always worked. I have an extended warranty so they replaced the TRS for free and I haven’t seen the issue again.
|05-26-2012 02:39 PM|
|Dylanjwhall||Did that in my 12, finally it wouldn't start, then was towed. they replaced my starter and all was good in the world again|
|This thread has more than 30 replies. Click here to review the whole thread.|