Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum > 1997 tj will not start. PLEASE HELP

Join Wrangler Forum Today


Thread: 1997 tj will not start. PLEASE HELP Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
06-14-2012 09:22 PM
Stevenkrans
Quote:
Originally Posted by Coldsteele
At least I'm not the only one who wasted 70 bucks
Sadly, no.
06-14-2012 09:20 PM
Coldsteele At least I'm not the only one who wasted 70 bucks
06-14-2012 09:17 PM
Stevenkrans When this happened to me...it was just battery terminal connections, after I also replaced the starter unnecessarily.
06-14-2012 09:06 PM
Coldsteele It starts now, my starter was never the issue. I guess it's something to do with the ignition because I can manually start it with a screwdriver. After I did that I could start it no problem
06-13-2012 09:11 PM
RUBI 4 MY MRS If battery is good & cables clean & tight proceed.If you’re sure the starter relay is clicking then the actuator pin & ignition switch & clutch switch are OK. Otherwise the relay won’t click. Make sure (not just look at) the #2 (40A) fuse in the PDC is good. If good pull the relay & test the #30 slot in the relay socket for battery voltage. If good make a short jumper wire & with the jeep in neutral jump across the #30 & # 87 slots. That should engage the starter & with the key on start it. If the jumper won’t engage the starter (at least click the solenoid) then the (small) wire to the solenoid is bad or the starter is bad. (New, I know)
06-13-2012 08:44 PM
Coldsteele well it can't be the clutch safety switch because I can hear it engaging when I let off the clutch or engage it again. and I started it by a rolling start, so it can't be the ignition switch either right? so It has to be a bad connection. thanks guys
06-13-2012 03:08 PM
50Johnbob
Quote:
Originally Posted by Coldsteele View Post
What could the issue be?
If the starter is good, you need to find out why you're not getting a 12v signal to the small wire on the starter solenoid.
The usual suspects are,
the clutch safety switch,
the ignition switch,
the starter relay,
or a damaged wire,
or a loose connection related to any of the above mentioned parts.
06-13-2012 02:44 PM
Shadowkraze
Quote:
Originally Posted by Coldsteele View Post
I shut the engine off yesterday morning and went to start it like 10 minutes later and all i got was a click. I roll started it to get to advance and i tested the battery, it was working, it held a charge fine. I bought a new starter, went home and put it in but it still wont start. Apparently the starter is not the problem because I bench tested my old one and It works fine. now that ive snapped a bolt off of the new solenoid i cant get the new starter disconnected from the battery wire...
someone please help. What could the issue be? connections?

Is this click you speak of the; "click" when you turn the key, or of the starter engaging and not turning? or a soft click like a Relay sound?

Based off your description, it sounds like your ignition switch is dead in the start position, or the start signal wire is damaged.
06-13-2012 02:41 PM
50Johnbob Disconnect the battery wire from the Jeep and remove it with the starter. Then you can put it in a vise or on your work bench so it will be easier to find a way to get the wire off of the solenoid.
06-13-2012 01:27 PM
Coldsteele
1997 tj will not start. PLEASE HELP

I shut the engine off yesterday morning and went to start it like 10 minutes later and all i got was a click. I roll started it to get to advance and i tested the battery, it was working, it held a charge fine. I bought a new starter, went home and put it in but it still wont start. Apparently the starter is not the problem because I bench tested my old one and It works fine. now that ive snapped a bolt off of the new solenoid i cant get the new starter disconnected from the battery wire...
someone please help. What could the issue be? connections?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 11:03 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC