|06-18-2012 01:37 PM|
|GoldenSahara00||Stinger made by me and stock rear bumper cut down etc.|
|06-18-2012 12:31 PM|
|06-18-2012 12:06 PM|
Smittybilt SRC Classic el-cheapo bumpers. Rear is bumper only. I would not recommend their tire carrier version. Less than $100 each. They have held up to some moderate abuse. Not even close to the strongest out there, but If I mess one up, i'm not out $400 bones a piece. It's just a bumper.
I use a Bestop tub mounted tire carrier.
|06-18-2012 11:36 AM|
|shipjim||[ATTACH]Attachment 133075[/ATTACH][ATTACH] I have a custom front and dirtworxx rear swingaway|
|06-18-2012 08:36 AM|
|06-18-2012 07:21 AM|
a resurrected ARB bumper, on my thrash wagon,
|06-17-2012 11:46 PM|
|03-05-2012 09:00 AM|
|03-05-2012 07:51 AM|
Smittybilt SRC front bumper. Got the matching rear on order.
|03-05-2012 07:32 AM|
.25" wall 3x4 tubing for the main body at 60" wide. Yeah... I know... it's wide, but I wanted a bit of extension on each corner for protection.
The 1" thick tow points drilled to 7/8" eyelets go completely through the entire bumper and welded under the pads 100%
The mounts are .25" plate material backed by 4x4x.25" pads backing the bumper.
The receiver is custom by me and clearance through the back. the recessed 7 -way RV connector was the add-on for future tows of a boat or small trailer.
and freshened up with paint and mounted for now while I go into design on the swing-away carrier.
The pivot point of my swing away is made of SS that I cut down to fit some Timken Bearings and Races for a 1.25" shaft.
End caps from mild steel stock and cut to accept shims to tighten bearings for pre-load once all is mounted on the swing-away.
STILL havent finish the swing-away... sigh....
|03-05-2012 07:29 AM|
Let's see your front bumpers!!
Show off your bumpers!
I wanna see your bumpers
Here is my front... ( pasted from a link above... )
.120 wall 2x6 metal
a little cut, grind and weld...
1" solid steel tow points with 7/8" eyelets
And finished off with Plasti-Dip!
And with my Engo E12000 installed with a Smittybilt raised winch plate and Hella 500FF's
|03-05-2012 01:10 AM|
Smittybilt Stinger, picked it up for $199.99 at 4wheelparts when it was on sale for a bit, even at normal retail it was only like $249.99 I think.
|03-05-2012 01:03 AM|
smittybilt SRC front and rear:
|03-05-2012 01:00 AM|
lets see your front and rear bumpers!!!!!
looking for some new bumpers if you have any pics of yours show em please, and say who makes them. thanks