|08-14-2008 09:03 PM|
I haven't been around.
I put everything together, marked where the upper bracket was, installed the upper backing plate but kept the screws loose and made sure it was going to line up.
I don't know what else to tell you. Without seeing what your situation is I'd hate to tell you wrong.
Call Bestop. Their customer service is top notch.
|08-13-2008 07:06 PM|
|4Jeepn||I had one of these. I think I installed the bracket that mounts to the roll bar 1st, then drilled holes for that, then based on where that was located did the bottom mount on the body and the body mount. Its been a while, wish I could offer more help.|
|08-13-2008 06:11 PM|
|08-13-2008 12:31 PM|
|florida_gat0r||If you can, take pics of it tonight. It will be easier if I can see if you are having the same problem I did.|
|08-13-2008 10:43 AM|
|08-13-2008 09:09 AM|
|florida_gat0r||Did you put the upper backing plate on yet?|
|08-13-2008 09:00 AM|
I have mounted the tailgate hinges and the upper sport bar bracket. It came with one for the YJ and the TJ. I am of course using the TJ bracket. When I install the upper bracket with it flush against the body tub, I made some small center punch marks from the inside to show me where the holes should line up with the upper hinge. The holes and the hinge are off. I'm not sure if I should adjust things, what to adjust first, or what next. My son has the Jeep at school right now. It is his Jeep. I'll try to post some pics this evening while I try to figure this whole thing out before I drill holes. Thanks and yes I am installing the one in the picture.
|08-13-2008 07:29 AM|
Okay, I'm going to assume you are installing this one. Not sure if there is a different one.
The upper body hinge and upper backing plate that came with mine were different than the ones I ended up needing. I have an '06 and the hinges are different. My advice is to make sure you install the tailgate hinge brackets and the upper backing plate. Then put the arm assembly on with the upper body hinge check your alignment there before anything. It should line up.
I had the pleasure of mounting and drilling everything like the instructions said only to realize I was given the YL upper body hinge and upper backing plate. So I have a couple extra holes.
I'll try to post some picture of it later if it would help. Try and post a pic of where your progress is right now.
|08-13-2008 01:21 AM|
|08-12-2008 11:32 PM|
|08-12-2008 08:55 PM|
Help with Bestop tire carrier!!!
Guys I need some help here. I am in the process of installing a Bestop rear tire carrier and have some questions. I can't seem to get the hinges to line up where the holes are going to be in the body. I have installed the sport bar bracket and only made small center punch marks to check things out and the holes are off. Can anyone guide me through this. The rest of the install has been good, I just want things to be right when I drill holes in the body tub. Pictures would be helpful. Thanks again.