Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum > Lighting Project

Join Wrangler Forum Today


Thread: Lighting Project Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
08-13-2008 05:15 PM
richp Also remember to use wiring loom, oh and rubber grommets if you do through a sheet metal hole. The wiring loom is at most auto parts stores, both solid and split.
08-13-2008 04:44 PM
Cal Raise your hood. At the top of the firewall will be 5 screws that will loosen the back section with the vent and wipers. Remove the screws and you can raise this part and place the harness between it and the fenders. Put back down and replace screws.Run the harness down the rubber seal by where the hood sets. I then slit one of the rubber plugs in the firewall to feed the harness into the drivers compartment. I sealed off the cut with rubber sealer. then its just a matter of finding a place for the light switch inside and hooking up the power.
08-13-2008 04:14 PM
vin211
Lighting Project

Good Day Everyone,

I have finally decided to start my lighting project. It isn't going to be much right now. I was planning on putting a set of Hella Fog Lights on the front bumer so that's good to go.

I have also installed windshield mounts for another set of Hella Lights. Now my question is, how would one get the necessary wiring under and through the hood to make the necessary connections? I wanted to ask any of you for suggestions that may have done this before.


Thanks,

Vin

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 10:32 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC