Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ Tech Forum > 1st 2nd and 3rd gear grind, grind in downshift?

Join Wrangler Forum Today


Thread: 1st 2nd and 3rd gear grind, grind in downshift? Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
07-11-2012 02:25 PM
camarozz Who replaced the clutch?

I didnt tighten my pressure plate correctly and had the same problem.

But I would suspect the line bleed first, especially if the system was opened for some reason.
07-11-2012 02:02 PM
0III0forlife yeah, the new slaves come pre-bled as a 1 piece unit with the master cylinder.

If yours is a bleedable unit, there is a bleeder screw in the slave just in front of where the line hooks to it. looks just like the bleeder on your brakes with a nipple on the end of it. if no bleeder, you get to spend the 250 bucks to get a new master and slave combo, but that is where your problem is....air in the system.

sometimes you can cheat by reverse bleeding the unit...make sure the master is full, take the slave out of the bell housing, and compress the rod as far as it will go, wait a few minutes, and pull the rod slowly back out. then repeat as many times as it takes till you dont see anymore air bubbles coming up into the master cylinder cup.
07-11-2012 01:15 PM
bassassassin it's the 2.5L, everywhere that i've looked on these forums theres nothing about how to bleed it, they say you have to buy the entire new cylinder for it. Cause it comes pre-bled or something of that manner. Not to sure, but if you know how? I'd surely enjoy you explaining it, thanks.
07-10-2012 07:22 PM
kik If you're serious with this post, why didn't you bleed the clutch? That's the problem. Too much air in the lines.
07-10-2012 06:42 PM
bassassassin
1st 2nd and 3rd gear grind, grind in downshift?

i have a 94 wrangler 4x4 and when i shift from 1st to 2nd and 2nd to 3rd, it grinds. i cannot downshift into 1 2 or 3, what is wrong? do i need synchros or a new slave cylinder, clutch was changed 2 weeks ago without the clutch being bled

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 05:55 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC