Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ Tech Forum > YJ Rear Bumper Bolt Pattern

Join Wrangler Forum Today


Thread: YJ Rear Bumper Bolt Pattern Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
07-17-2012 05:00 PM
ThePhantomPatriot
YJ Rear Bumper Bolt Pattern

(Mods: if this thread is supposed to be in the Fab thread instead of YJ, please move it)

I'm designing an aftermarket set of bumpers, both front and rear, for my YJ. I was able to find the front bumper bolt pattern on here, however I can't find the pattern for the rear bumper.

What I need is the measurements (center to center & hole diameter) for the bumperette holes, as well as how far between the driver and passenger groups. Also I need the measurements for vertical hole in the bottom of the frame right near the rear bumper. I'm planning on using 8 bolts on the rear bumper & crossmember, which I understand is weak, and then have my tow hook mounted upside down as well as steel reinforcement tabs going from the bumper to the frame, so I would need the measurement from the center of the frame hole to the face of the crossmember as well as the diameter (I think it's 7/16").

So:
Diameter & Spacing of bumper crossmember (bumperette) holes
Diameter & Spacing of vertical frame holes

Before someone posts "why don't you take your bumper off and measure" I don't have the proper tools to do so at this time.

Thanks.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 11:27 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC