|07-26-2012 03:48 PM|
It's not a requirement but if they have been in there for a long time the tend to freeze in place and a torch helps loosen them. I'd use a u joint press at the least tho and a big hammer or two. I have a cheapo harbor freight u joint/ball joint press. It's not the best but it gets the job done. Use the hammer to hit the ears of the shaft to help relieve tension while removing don't beat them though as you can deform them or gouge the cap journal. If you have access to air tools an air chisel to remove the retaining clips does wonders and an impact drill to operate the press speeds things along.
(edit) a vice to hold the shaft will make things easier as well.
(edit 2) I'm horrible at thinking of everything at once. There some good write ups on here and across the web of the whole process. I'd post a link but for some reason my phone wont let me right now. Do a search on here as its a common maint item that most if not all jeepers have done at some point.
|07-26-2012 03:37 PM|
Do you have to use a torch to get them off? I know nothing about them. Nor do I have a torch lol.
It is a 2006 Rubicon that has about 210000 miles and most of the stuff "underneath" is OEM, minus the exhaust system.
|07-26-2012 03:31 PM|
|Pirates-Rubi||Yes they would. Had the same problem with mine last year and the bearing caps were almost rusted away. I stupidly overlooked them during the maint check. Replace both at the same time and if they are the factory ones a torch is going to be your best friend.|
|07-26-2012 03:29 PM|
|07-26-2012 03:21 PM|
If the u-joints were loose would that do it?
|07-26-2012 02:34 PM|
|Dextreme||Most common are front axle u-joints starting to fail or something loose in the steering joints.|
|07-26-2012 02:26 PM|
help needed clanking when turning
I have a 2006 Rubicon and when I make slow turns I can hear something underneath clanking as I make the turn. Anyone know what it might be? Help! Thanks.