Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > CJ Jeep Forum > CJ General Discussion Forum > dana 44 axle

Join Wrangler Forum Today


Thread: dana 44 axle Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
08-12-2012 10:52 AM
RubiconRich Scout 2 axle front remove knuckles turn min 6 degrees (I have 4" lift went 10 degrees) If wanting CJ wide track cut 3 5/8" off drives side. then you have to get your pinion anlgle right. cut off old spring pad weld on new one. go with drivers side blank chrome molly shaft cut and spline.
07-26-2012 06:04 PM
Dempsey It's about 60-61". It will not fit without work. You will need to outboard your front springs to match the width of the perched on the axle. Also the inner c's on a scout 44 are set at 0*..this is bad. Should be closer to 6*. A waggy 44 is a better front because the c's are close. If you want to go to 5 on 5.5 bolt pattern you use ford brakes. I might know someone with a waggy front they sell.
07-26-2012 05:39 PM
CJ-John Lot's of info here! Jeep Axle Swaps: Front Dana 44
07-26-2012 04:52 PM
BIGLIFTER76
dana 44 axle

does any one know the width on Scout II dana 44 axles... I was wondering if it would work in a cj5 with no machine work?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 12:11 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC