|09-12-2008 09:19 PM|
|orange05tj||I have an adjustable track bar|
|09-12-2008 08:01 PM|
Install an adjustable TB if you want to re-center your front axle.
|09-12-2008 07:56 PM|
|timritchieblue||everone with 3" lift in the front, what did you do with the track bar? i have a 2", and my front is off centered, i dont want it any worse?|
|09-11-2008 09:14 PM|
with the 1.25" BL and 1" MML you can get rid of the TC drop if you have one.
if you ant it cheap you could install 1" spacers in the rear and 2" spacers in the front. that will also work with 2" springs.
|09-11-2008 09:09 PM|
3" lift, 1" spacer up front, 1.25 BL on 33's. I have plenty of clearance.
|09-11-2008 09:08 PM|
Okay thanks. Good news and bad news I guess.
|09-11-2008 09:05 PM|
you donŽt need a DPA. I have 2.5" springs with 2.5" spacers in the front and 2 spacers in the rear and it works fine.
the 1" spaer will lift the front to the same height than the rear. youŽll need a 1.25" BL/1" MML for 33s.
|09-11-2008 08:56 PM|
Thanks for the replies. I think I'm having a senior moment, but, I guess what I'm wondering is - if I add a 1" spacer to the 2" springs - that would sort of make it a 3" lift - yes? So then do I need a drop pitman arm or something to correct the steering, or would it likely be okay?
And then also wouldn't that spacer give the same clearance in front as a 1" BL would? So add to that the flat fenders and then wouldn't I have enough clearance to run 33s without the BL? BTW - I run Soft 8s so they do stick out farther than OEM wheels.
It seems to make sense to me - but I've never heard of anyone doing it so there must be a reason.
|09-11-2008 06:47 PM|
|orange05tj||I have a 3" FT lift, and put a 1" spacer on the front to level it off, worked out good, plus I needed it for the winch. 2"+1" BL will be fine for 33's. I ran it for a while|
|09-11-2008 04:57 PM|
|Jma20a||its fine to run a spacer over the spring, as for enough room for 33's i think you still have to go with the body lift, but im not 100% sure.|
|09-11-2008 04:31 PM|
2" Spring Lift With Spacer?
I have a 2" Pro Comp spring lift on my '06 LJ. The front sits 1" lower than the back (measured at the rocker panels behind the front tire and in front of the rear tire.) If I installed 1" spacers on top of the coils in front to level it out would it cause any issues - such as steering problems? Anyone done this?
Also - if this is okay to do would it likely give me enough clearance to run 33" tires without a body lift? (I currently run 32s) I would also be replacing the oem fenders with the Xenon flat fenders pictured below.
(I realize I could just do a 1" body lift, but I want to level it out if possible and I was planning on those fenders anyway.)