|09-26-2008 11:12 AM|
|x98cobra||cool thanks ill check my parts stores and 4x4 store|
|09-24-2008 08:55 PM|
|09-24-2008 08:08 PM|
|09-24-2008 07:58 PM|
|09-24-2008 06:13 PM|
|Triple88a||For the rear? there is a hole underneath the frame (if not you might have to drill one) which is where you put a regular wrench just to hold it tight, then you tighten it with a socket or whatever you have from the outside.|
|09-24-2008 06:00 PM|
|x98cobra||So jerry how do u get a socket or wrench in through the frame to tighten the bolts??|
|09-24-2008 01:40 PM|
|09-24-2008 12:19 PM|
Tow hooks are bolted to the frame, they do not use the bumper at all, aside from the bolts sometimes passing through the bumper to the frame below like if you installed the Mopar hook (which I would not recommend).
For the rear, tow hooks are most commonly mounted like the below photo shows. The frame already has one hole there, you just drill one more. You do NOT (!) drill all the way through the frame, you just drill through one side of the frame and the washers and nuts are fished up inside the frame through a slot in the bottom that is pre-existing.
This method is about the best and strongest for the rear and is how I did mine 10-12 years ago. As you can see, you can pretty much use any kind of rear bumper and not have it affect the tow hook itself.
For the front, you can install tow hooks with nearly any bumper, including the OE bumper. The tow hook bolts pass through the bumper to the frame below. For the most part, only round tubular bumpers can make installing front tow hooks a challenge.
|09-24-2008 12:11 PM|
|x98cobra||ok thanks guys i guess ima get me a new rear bumper or reciever hitch|
|09-24-2008 07:45 AM|
You can put tow hooks (or D-rings) onto your front bumper as long as you re-use the factory mounts on the top of the bumper that bolt to the frame.
I would not suggest welding anything to the stock bumper for a pick point. It will not handle the stress.
|09-24-2008 07:25 AM|
|tj1230||If you wan't to keep your stock rear bumper, get a receiver hitch. You can mount a D ring to the ball mount or you can buy them that way. Works just as good.|
|09-24-2008 01:32 AM|
|Triple88a||both front and rear bumpers are too weak to weld on and pull. Maybe 14 gauge ... If you want to add D ring mounts you will have to mount it to the frame bolts (or get a new bumper). It should be pretty easy to make 2 L shaped brackets though.|
|09-24-2008 01:08 AM|
Stock rear bumpers for tow hooks
Is it safe to drill holes in my stock 04 rear bumper for mounting tow hooks? or is it best just to buy the rear bumper that has the tow hook mounts?? and which are better the d-shackles or tow hooks for strength, i dont do any insane off roading but need them just incase