Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > WF Local > WF Local Forums for Your Region and State > Oregon Jeep Forum > New Project - Rear Bumper replacement

Join Wrangler Forum Today

Thread: New Project - Rear Bumper replacement Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
08-25-2012 02:07 PM

finally ready for powdercoat, check out the new pictures
08-17-2012 02:21 AM
oregonmp03 got it all welded together and mounted up along with the jerry can quick disconnects. Just need to finish all the endcaps, latch, and the actual jerry can holders, then off to powder coat
08-16-2012 08:25 PM
Baby Huey Good Job !

Hopefully I can get started on mine this winter, I want to build a set of sliders too to cover up the naked hole in the side of the body...

Good goin ! "BH"
08-16-2012 02:46 PM
oregonmp03 nope, didn't do any altering of the jeep body at all, the only actual alteration to the jeep itself was two bolt holes in the frame
08-16-2012 11:30 AM
scottmphoto Did you cut your body on both rear corners?
08-16-2012 02:44 AM
oregonmp03 reposted here with the new updates
07-30-2012 08:34 AM
Cold Nicely done!
07-30-2012 01:02 AM
New Project - Rear Bumper replacement

Built this on Saturday using 3 x 4 " steel and a piece of 4" flat iron for the top to clean it up. I'll be adding the oversized tire carrier once the cylinder for the swing arm shows up in the mail. Also got the CB antenna bracket up and mounted (temporarily until the carriers finished). Everything will be powder coated after it's done.

And yes I think the passenger side is a bit low, need to fix my bolt holes before it's finished. Had to eye ball it the first time.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 07:14 AM.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC. is not in any way associated with the Chrysler Motors LLC