|08-25-2012 02:07 PM|
finally ready for powdercoat, check out the new pictures
|08-17-2012 02:21 AM|
|oregonmp03||got it all welded together and mounted up along with the jerry can quick disconnects. Just need to finish all the endcaps, latch, and the actual jerry can holders, then off to powder coat|
|08-16-2012 08:25 PM|
Good Job !
Hopefully I can get started on mine this winter, I want to build a set of sliders too to cover up the naked hole in the side of the body...
Good goin ! "BH"
|08-16-2012 02:46 PM|
|oregonmp03||nope, didn't do any altering of the jeep body at all, the only actual alteration to the jeep itself was two bolt holes in the frame|
|08-16-2012 11:30 AM|
|scottmphoto||Did you cut your body on both rear corners?|
|08-16-2012 02:44 AM|
|oregonmp03||http://www.wranglerforum.com/f33/new...er-180779.html reposted here with the new updates|
|07-30-2012 08:34 AM|
|07-30-2012 01:02 AM|
New Project - Rear Bumper replacement
Built this on Saturday using 3 x 4 " steel and a piece of 4" flat iron for the top to clean it up. I'll be adding the oversized tire carrier once the cylinder for the swing arm shows up in the mail. Also got the CB antenna bracket up and mounted (temporarily until the carriers finished). Everything will be powder coated after it's done.
And yes I think the passenger side is a bit low, need to fix my bolt holes before it's finished. Had to eye ball it the first time.