|01-10-2014 10:56 PM|
|01-10-2014 10:16 PM|
|WBN3||Now THAT is creative problem solving... high five to you!|
|01-10-2014 04:59 PM|
I bought these and stuck them all over the back of switch and resistor and connectors. Figure if they are going to make heat take it away like a radiator. Have had no further melting since. My connectors are a little melted from before and I have a new switch and resistor same fan. Been around 2 years. I reviewed them can look at the date. ENZOTECH Memory Ramsink BMR-C1 (Forged Copper Heatsink)
|01-10-2014 03:49 PM|
Did this work?
|11-12-2012 04:34 PM|
|freeskier||Look at part 973-416, same exact thing but it's a kit with the resistor and pigtail. When doing the "check your fit" it says it fits. I'd say it's an error in the system, 973-305 should work.|
|11-12-2012 03:42 PM|
Thanks in advance.
|08-22-2012 06:08 PM|
|08-22-2012 06:00 PM|
That looks like the right model. Nice find!
Don't forget your blower motor might be the reason it all melted in the first place.
|08-22-2012 05:53 PM|
The product description said "2001-97 Jeep Cherokee, Wrangler..."
|08-22-2012 05:40 PM|
|Jerry Bransford||Won't work, that is for the newer style resistor pack that uses a different connector.|
|08-22-2012 05:31 PM|
|HeyItsWinner||I just found this product 2002-2006 Jeep Wrangler HVAC Blower Motor Resistor Connector - 2973305 Replacement - Climate Control 02-06 Wrangler HVAC Blower Motor Resistor Connector - PartsGeek.com Do you think it could fit my new blower motor resistor even though it is labeled for 2002 - 2006 (I have a 97 tj wrangler btw)|
|08-22-2012 05:24 PM|
|08-22-2012 05:19 PM|
|Jerry Bransford||If I can find the p/n for the pigtail in my parts manual tonight I'll post it up for you.|
|08-22-2012 05:11 PM|
Now i just need to get the female resistor connector. I think... this: IMAG0559 | Flickr - Photo Sharing! because my old one(as you can see is melted) but i just don't know where i could buy it?...
|08-22-2012 04:54 PM|
I ended up cutting the connector off on my '97 after it melted, I simply spliced the wires together. A possible cause for the wiring and connector to have gotten hot enough to melt is a bad fan motor. When the HVAC fan motor goes bad, it often starts drawing much more current than the wiring and connector was designed for.
I have a good resistor pack I no longer need since that Jeep was stolen and my newer TJ uses a different type of resistor pack, PM me with a reasonable offer if you want it.
|08-22-2012 03:56 PM|
Blower Motor Resistor Harness MELTED
Hello my fan setting only worked on high so I opened up the blower motor resister to find out that it was melted in to the connector and I am wondering how would i fix the connector so that i would be able to replace the resistor itself? here are some pictures for more details
Anyone know where i can buy the harness/connector for my 97 wrangler?
Or is it called a pigtail?
If you cannot see the picture try right clicking and then open it up :]
So any help?