|09-08-2012 10:15 PM|
|Jaredm||thanks for the replys! the previous owner had installed the body lift, i don't care for it but i don't have the $$ right now to switch over to a suspension lift but its in the works. i will try engaging it on the fly and see if i can get it to engage, and also look into the adapter plate. Thanks again|
|09-04-2012 09:59 PM|
|Rubicondon53||Did you install the body lift or did the previous owner?|
|09-04-2012 09:27 PM|
|jeepwayoflife||Yes you will have problems with that high of a body lift. If you don't already have a linkage adapter, you will want one. Make sure you are moving in a straight line under 50mph when you pull the lever to go from 2hi to 4hi. You don't need to push the clutch in, it engages on the fly. Make sure you don't use 4hi or 4lo on high traction surfaces like concrete, even if you are going in a straight line. Our transfer cases are pretty darn tough and rarely have problems, its probably just an alignment issue because of the body lift|
|09-04-2012 09:19 PM|
|09-04-2012 09:07 PM|
|HarryJeepGuy||The 3" body lift is going to cause issues, usually people can't get into 4 lo because the handle and lever can't go all the way back. 4 hi works best for me when the Jeep is rolling (all tires at the same speed, not rear spinning front still). It will usually grind if I'm not moving when I let the clutch out. Try it while moving, clutch doesn't matter in or out.|
|09-04-2012 08:59 PM|
|Vinsfeld||I just bought my Jeep on Sunday, how do you change to the different drives? Just push in the clutch? What should the Jeep be in for normal driving?|
|09-04-2012 08:42 PM|
Its probably the body lift causing your issues, for around $40 you can get a T-case shifter adapter from Advance adapters which should cure your issues.
Stand aloneJeep TJ transfer case shifter bracket | Advance Adapters
|09-04-2012 08:30 PM|
|HeyImWade||I had the exact problem and I found that when you pull the transfer case all the way up to 4H it goes halfway in 4H and halfway in neutral (for me and maybe you). So I pulled the lever not all the way until it stopped and it works fine. What I'm saying is try pulling the lever to around in between 2H and 4H because it's probably not locking in all the way.|
|09-04-2012 08:25 PM|
4 hi just grinds, is it blown or just not engaging?
i have a 97 wrangler sahara 4.0 with manual trans with 3" bodylift 33" tires, when i put the tranfer case in 4 hi, just pulling the handle straight back with clutch pressed down, it feels as if its engaging but when i let the clutch out it just grinds and the jeep dosent move at all. 4 lo works fine and 2 hi obviously but when i want to go offroading 4 hi is nice. i just bought the jeep in january and have only attempted to use the 4wd on a handfull of occasions now and have always been able to get out or get pulled out with the 4 lo. soo i guess what im wondering is if its just not engaging because of the 3 inch bodylift and the linkage isnt quite right or if my 4 hi is just gonzo and i need to get my transfer case rebuilt...