Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ Tech Forum > just bought a yj didn't notice 33 in tires don't clear fender

Join Wrangler Forum Today


Thread: just bought a yj didn't notice 33 in tires don't clear fender Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
09-23-2012 04:57 PM
Kingcat That is a 2.5 inch ome lift and like 1/2" shackles. Not 3" lift shackles like you stated. I have a fabtec 3.5 and have room to go to 35's
09-22-2012 12:36 PM
cakes567
Quote:
Originally Posted by camarozz

Yes, newer leafs change it.

Matter of fact I saw your pictures first and was going to suggest that you did not have stock springs.

Are those a version of the boomerang shackles? Cant say Ive seen those before.
The whole kit is made by old man emu. Shocks, springs, and shackles.
09-22-2012 11:30 AM
camarozz
Quote:
Originally Posted by cakes567 View Post
Im sure its 3in. My leafs are after market. Could that change it? I also just checked both tire size and tire clearance and I still have plenty of room when I off road and get the front flexing even at a full turn it still will not rub. Iv checked all of that before. The only thing it will do is hit the out side eage of the fender flairs on the rear but the other back tire of the jeep have to be like 2.5ft off the ground to do it.
Yes, newer leafs change it.

Matter of fact I saw your pictures first and was going to suggest that you did not have stock springs.

Are those a version of the boomerang shackles? Cant say Ive seen those before.
09-22-2012 10:49 AM
Fweaky You can get an inch of relief by trimming the flairs. It may save you a few bucks and it will drive better if you can avoid lifting it too much.

I know this isn't a great picture but you can trim them up to the step on the flair pretty easy with a box cutter.
09-22-2012 10:33 AM
cakes567
Quote:
Originally Posted by cakes567

Im sure its 3in. My leafs are after market. Could that change it? I also just checked both tire size and tire clearance and I still have plenty of room when I off road and get the front flexing even at a full turn it still will not rub. Iv checked all of that before. The only thing it will do is hit the out side eage of the fender flairs on the rear but the other back tire of the jeep have to be like 2.5ft off the ground to do it.
There you go. Nothing Is cut out, 33"x12.5"x15r size tires, my shackles are not 10" long. Nothing rubs bumps and or scrapes at a full turn in the front or the rear. If I was lieing or didn't no what I was talking about then I wouldn't have gone threw the trubble to do the lift. and take all the pics to show u
09-22-2012 10:21 AM
cakes567
Quote:
Originally Posted by 0III0forlife

I would have to say bullsh*t on that quote. In the 1st place in order to have 3 inches of lift from the shackles, as stated in one of the previous posts, your shackles would have to be 10 inches long.

Stock shackles are 4" in length, and for every inch that you extend a shackle, it creates 1/2" of lift.

And if you think that 3 inches of added lift is adequate to clear 33" tires, then either your tires are measured as wrong as your shackles are, or your tires rub and you dont know it.

A 4" suspension lift is minimum clearance needed to clear 33" rubber. If i were doing it to mine, i would put a 4" suspension lift as well as a 1" body lift and an 1 1/2" shackle lift. But thats just me. If i pay 250+ per tire, the last thing i want is for my fender to chew the tread off of it.

My YJ has a 4" suspension, 3" body, and a 1 1/2" shackle lift, for a total of 8.5" of lift so i can clear my 35's.
Im sure its 3in. My leafs are after market. Could that change it? I also just checked both tire size and tire clearance and I still have plenty of room when I off road and get the front flexing even at a full turn it still will not rub. Iv checked all of that before. The only thing it will do is hit the out side eage of the fender flairs on the rear but the other back tire of the jeep have to be like 2.5ft off the ground to do it.
09-22-2012 09:19 AM
DILLIGAF With 33's you wanna do a spring leaf lift, and wheel spacers, The RC-4" lift kit comes with all the stuff needed, Except for the shackle bolts that might need to be cut out due to rust. And takes about 8 hrs with a friend and well equipped garage.
09-22-2012 09:11 AM
0III0forlife
Quote:
Originally Posted by cakes567 View Post
Really? I have a 3in shackle lift on mine with 33x12.5x15r and I still have plenty of room left.
I would have to say bullsh*t on that quote. In the 1st place in order to have 3 inches of lift from the shackles, as stated in one of the previous posts, your shackles would have to be 10 inches long.

Stock shackles are 4" in length, and for every inch that you extend a shackle, it creates 1/2" of lift.

And if you think that 3 inches of added lift is adequate to clear 33" tires, then either your tires are measured as wrong as your shackles are, or your tires rub and you dont know it.

A 4" suspension lift is minimum clearance needed to clear 33" rubber. If i were doing it to mine, i would put a 4" suspension lift as well as a 1" body lift and an 1 1/2" shackle lift. But thats just me. If i pay 250+ per tire, the last thing i want is for my fender to chew the tread off of it.

My YJ has a 4" suspension, 3" body, and a 1 1/2" shackle lift, for a total of 8.5" of lift so i can clear my 35's.
09-22-2012 09:06 AM
Xpress You said you rub when you turn? you're likely rubbing on the inside of the fender well. Adjust the steering stops or put on spacers.

Quote:
Originally Posted by cakes567 View Post
Really? I have a 3in shackle lift on mine with 33x12.5x15r and I still have plenty of room left.
That's obsurd, and dangerous. Shackles of that length can be a safety issue.
09-21-2012 07:29 PM
cakes567
Quote:
Originally Posted by denisbaldwin
Depending on how much it's clipping/rubbing, you could trim out the front fenders. Even with a 3 inch body lift and 2 inch shackle lift, my 33s still rub at full turn. Granted, they rub on the inside, not the outside.. but I think that has more to do with wheel selection than anything else.
Really? I have a 3in shackle lift on mine with 33x12.5x15r and I still have plenty of room left.
09-21-2012 02:48 PM
denisbaldwin Depending on how much it's clipping/rubbing, you could trim out the front fenders. Even with a 3 inch body lift and 2 inch shackle lift, my 33s still rub at full turn. Granted, they rub on the inside, not the outside.. but I think that has more to do with wheel selection than anything else.
09-21-2012 07:54 AM
BAP what fritz65 said,,,thats what i have and im very happy , check and make sure your not rubbing your sway bar and leafs aswell,,,,mine does with the stock wheels and 33x12.50s,,,,,
09-21-2012 06:33 AM
fritz65 You can get a nice rough country 4" lift for under 500 and the 33's will fit fine
09-21-2012 06:15 AM
shoepick Your shackles would have to be 6" longer than stock shackles for a total length of 10" and that's insane.
09-20-2012 09:36 PM
cakes567 Shackle lift. Somewhat easy to install and not that expensive. Id go at least a 3" lift. That's what I have.. same tires and lift and it works perfect. Check out quadratec.com and look them up. And I don't think that a tj lift would work on a yj because the tjs have coil springs and the yjs have leaf springs
09-20-2012 09:36 PM
camarozz Well, you could do body lift, and I suspect it is the cheapest way but honestly I dont think it is the best for the investment.

Can you determine how much you need to make it clear?

Have you looked at the body kits and compared them to a legitimate spring lift?

You may be able to get a 'helper spring' kit or 'add a leaf' to get the clearance you need for a decent price.

Are you going to do the work yourself?

My opinion, I would save up and just buy a decent spring lift kit. Probably about the same amount of work, and the best investment as I see it for clearance.
09-20-2012 09:18 PM
FrankieDR89
just bought a yj didn't notice 33 in tires don't clear fender

Like the title says I just bought my first jeep 95 yj, and I didn't notice until the second day I was driving it around that its 33" tires where scraping the fenders every time I made a sharp turn, this jeep is still stock has no modifications or lift of any kind.
My first question is due to my budget right now what would be the cheapest way of clearing the tires?
Second question is I found someone with a body lift kit for a 05 tj, would that fit on my 95 yj?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 12:58 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC