|11-17-2008 10:56 PM|
thats the screw u have to adjust (the nice and rusty one)
|11-17-2008 10:16 PM|
|00 grtj||if you cant find it, grind it|
|11-17-2008 07:48 PM|
|TJDave||Jerry beat me. He types faster and has better knowledge. I'd go with that.|
|11-17-2008 07:46 PM|
|carwashben||no, it is a tj, and it is all automatic. But i will definetely check that out about the slipping out of 4lo. I have just been trying to troubleshoot the whole thing because it jsut feels nasty when you are leaving 4lo, and when you are in the neutral stage, you cant really go back to 4lo or to 4hi without grinding.....It seems fine leaving 2hi and going to 4hi or 4lo, but leaving 4lo is where the problem seems to lie.....and I cant put it in 4lo if i am at a stand still without it grinding really badly.....|
|11-17-2008 07:45 PM|
|11-17-2008 07:38 PM|
Popping out of 4Lo usually indicates the shift mechanism has slipped out of adjustment. The rod to the t-case normally pulls out a little if the bolt that holds it in place loosens which will prevent it from shifting all the way into 4Lo. It's easily adjusted back where it should be once you get underneath and see how it works with someone shifting it from the top.
Grinding while shifting into 4Hi is a little more troubling. Your Jeep didn't by any chance come with manual hubs up front did it? Or is it a YJ?
|11-17-2008 07:30 PM|
|carwashben||yea but what if it still grinds when i go from 4lo to 4hi? even if i am doing all of the above? any sugestions? And why might it pop out of 4lo?|
|11-17-2008 07:24 PM|
|Triple88a||i assume he ment from 4hi to 4 lo.. anyways if you are not in neutral, you will get a grind... I always shift my tranny to neutral before i shift the tcase.|
|11-17-2008 07:22 PM|
|carwashben||sorry sorry, i meant 4lo|
|11-17-2008 07:20 PM|
|JCS05Rubi||For 4hi to 4Lo, make sure your automatic transmission is in Neutral and you are not moving. 2hi to 4hi can be on the fly up to 55mph, but 4 hi to 4lo and 4 lo back to 4 hi must be with the transmission in neutral and the vehicle not moving. Sometimes you may have to put it back into 4hi, back into drive or reverse, move half a foot or so, and try again, but the trans MUST be in neutral and vehicle moving less than 3mph to go to and from 4lo.|
|11-17-2008 07:10 PM|
|11-17-2008 07:09 PM|
|Jerry Bransford||From 2Lo to 4Lo? You have Tera's 2Lo kit installed?|
|11-17-2008 07:03 PM|
shifting from 4lo to 4hi.
I have a 1999 tj wrangler automatic. When i shift from 2lo to 4lo, it grinds. I get stuck in the neutral position and cant go anywhere without it grinding. It also will slip out of gear after a few seconds unless you apply upward pressure against the shifter...Any sugestions or such!?