Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ General Discussion Forum > replace Factory speakers in dash?

Join Wrangler Forum Today


Thread: replace Factory speakers in dash? Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
12-03-2008 10:18 PM
87YJWrangler I dont have doom lights, my E-Brake isnt hooked up anyways and also I dont have any torx bits(
12-03-2008 08:59 PM
YjMopower Good luck I remembered when i tried to figure this out ,i couldn't grab them from underneath so i got my dremel and cut a rectangle around it, you'll then see how its attached pretty werid but now you see why you couldn't just yank it off.I then cutt out some metal grill sheet and just put it right back where the old metal piece was.
12-03-2008 08:19 PM
The Sos Mine was a real pain cause the studs were bent and stripped. I had to cut them off and add some bolts with spacers to keep the speaker off the dash. Lucky for me I the dash apart for paint.
12-03-2008 08:03 PM
AWCFlyr I wound up doing the same as racer, except I pulled the tach out to get at the upper nuts on the driver side. Made reaching the top two much easier-but there is no easier way for the passenger side. Just remember that if you replace the stock speakers you may want to cover the replacements with a thin stretchable fabric to act as a dust/water barrier from your cones. The speaker vents allow for a lot of dirt/water to travel directly to them without something in the way.
12-01-2008 08:41 PM
racer-xerols I got both mine out without removing the dash...maybe I just have doublejointed wrists I did have to drop the ebrake release assembly on the driver side, and pulled both dome lights out to make room, but I got both my stockers out and the Polk Audio replacements in. They mount to studs on the inside of the dash - all you have to remove is 4 nuts per speaker.
12-01-2008 07:14 PM
crashmurdock Thanks for the all the replys looks like Ill be waiting for some warm weather take the hard top off fold down windsheild have a beer then add some kickers and jam
12-01-2008 04:17 AM
fbtased2002 When I did it i fought for an hour trying to reach under the dash with a wrench and every time I got it back there it stuck to the magnet on the speaker! should have seen that coming. Anyway I finally just folded the windshield down and pulled the dash back a few inches and there they were. It is only a few bolts and WELL worth the extra time to make it super easy. I have a set of speakers for my new jeep just waiting for some free time. good luck
11-30-2008 07:04 PM
rebelBullDawg325 def not easy. i was able to get my drivers side out with the dash still attached but couldnt get anew one in, and the pass side dash had to come out. i;m actually replacing my dash now and am trying to design a way to make it possible to pull and replace the speakers without fooling with the dash
11-30-2008 07:00 PM
jpdocdave i can tell you for sure its not that. gotta be the only thing they designed as a pain in the neck, everything else is accessible accept the dash speaker.
11-30-2008 06:13 PM
crashmurdock Thanks I was hoping I wouldn't have to do that. Probably not a half hour job I guess.
11-30-2008 04:01 PM
jpdocdave as far as i remember its a pain. i think you have to pull the dash out, not all the way, but you have to loosen the whole thing and i think you can sneak them out. not easy though.
11-30-2008 02:53 PM
crashmurdock
replace Factory speakers in dash?

I have a 93 yj still has factory speakers they don't sound bad but I got some 4x6 kickers given to me they are brand new so I'm going to try them out. How hard is it to get the old ones out? How much dash do you take apart or do you just reach them from the back? Thanks any info appreciated.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 11:45 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC