Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > JK Jeep Wrangler Forum > JK Tech Forum > Catalytic converter

Join Wrangler Forum Today


Thread: Catalytic converter Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
12-04-2008 10:02 AM
rdougherty137 i want to put a snorkel on it but between the airbox and the snorkel that will fit with the supercharger it'll be about an extra thousand so maybe down the road a little way
12-02-2008 04:18 AM
Hilldweller
Quote:
Originally Posted by rdougherty137 View Post
I put new headers on followed by new plug wires since the stock wires were visably arcing. well when i put on the new plugs i didnt pay enough attention to the order since they aren't not in the same order on each side. while figuring it out enough unburnt gas made it to my cat to pop the code in the computer. so i was going to run high flow cats and 2.5 inch pipe since i can legally take the cat out and replacement. i am going to be supercharging in the very near future so i want the extra flow.
Holler at Gibson; I think they have a complete system and should be able to answer technical questions.
Will you have access to a dyno after the exhaust job? I'd be very interested in the numbers after a full exhaust and maybe a snorkel.... ....you are adding a snorkel to deliver the coolest air, right?
Good luck on the project; it's a worthy one.
12-01-2008 06:15 PM
rdougherty137 I put new headers on followed by new plug wires since the stock wires were visably arcing. well when i put on the new plugs i didnt pay enough attention to the order since they aren't not in the same order on each side. while figuring it out enough unburnt gas made it to my cat to pop the code in the computer. so i was going to run high flow cats and 2.5 inch pipe since i can legally take the cat out and replacement. i am going to be supercharging in the very near future so i want the extra flow.
12-01-2008 05:29 PM
jpdocdave why aren't they functioning right? under federal law they are covered under warranty for at least 80k or 8 yrs, some vehicles are 100k.
12-01-2008 03:50 PM
Hitchhiker Maybe this file attachment will help.

Regards,
12-01-2008 02:23 PM
rdougherty137
Catalytic converter

my cats arent functioning properly and i went to have them replaced with two high flow. I was told that the jk has four. this leaves no resonators. so does anyone know what the set up is whether its four cats or two cats and two resonators with some technical back up so i can get this fixed

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 08:52 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC