Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > CJ Jeep Forum > CJ General Discussion Forum > thoughts on a t-18 transmission

Join Wrangler Forum Today


Thread: thoughts on a t-18 transmission Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
10-13-2012 01:17 PM
Cj7otr
Quote:
Originally Posted by RubiconRich
and don't forget to add a twin stick to the 300!
Done!
10-12-2012 07:51 PM
RubiconRich and don't forget to add a twin stick to the 300!
10-12-2012 12:04 PM
jrussblues
Quote:
Originally Posted by Cj7otr

I'm going to put my 6:1 T18 on my Dana 300 with the 4:1 low gear conversion. I'm assuming it will become, for all practical reasons, a three speed with crazy low 4wd capabilities.
Yep, I'm running a final ratio of 30:1 in high and 1st gear is useless on the street and I'm running 35's.
10-11-2012 09:15 PM
Cj7otr
Quote:
Originally Posted by RubiconRich
I have a granny low T18 bolted to a 1980 Scout Dana 300 now that's the cat's butt. LOL
I'm going to put my 6:1 T18 on my Dana 300 with the 4:1 low gear conversion. I'm assuming it will become, for all practical reasons, a three speed with crazy low 4wd capabilities.
10-11-2012 07:51 PM
RubiconRich I have a granny low T18 bolted to a 1980 Scout Dana 300 now that's the cat's butt. LOL
10-09-2012 06:36 AM
lynn I installed a Jeep T18-1B in my '71. Best single mod I made to that rig over 16 years.

The tranny did need to be modified. Mine came out of a full size Cherokee, and had a ~12" input shaft. I had to replace the input shaft with a 6.5" one. Not too difficult, instructions are out on the net at various places.

I suggest you look at Parts Mike as a source for anything you need for your T18 installation. Parts Mike has been doing/providing parts for T18 swaps in CJs for more than 20 years.

Also check out Novak for any adapters you may need. Look at Novak's website, click on "Knowledge Base" and read about T18 info, and how they can also help with your T18 swap, with adapters, specialty pieces, etc.

No matter how much you spend on doing this swap, once you get your rig offroad and see the difference it makes, you'll never regret it!!

Good luck!

EDIT: I just re-read that the T18 is part of the project you just bought. If you're lucky, it's already installed, and you can just use the souces I cited as back up for info and parts if needed...
10-07-2012 09:50 PM
jrussblues Correction. 435 is 6.62/1. With 4.56 gears I'm just shy of 61/1 in granny gear low.
10-07-2012 09:45 PM
jrussblues Amc produced an astonishing 13 different t-18 tranissions. The golden egg you seek is a 76-79 cj7 t-18 or a swap from a ford truck. I just finished a np435 because almost all of them are geared at 6.92/1 granny and were put in ford trucks for something like 30 years. If you already have a amc v8 then you will only need a trans case adapter and a pilot bushing. If you have am i6 you will need the bell housing as well...maybe clutch linkage as well but not certain. On the plus side the t18 may bolt straight up to your skid, I moved mine back, dropped it an inch and redrilled holes and trimmed a hair off of the front of the skid lip to fit it in. Its a pretty tall transmission. On the plus side I paid less for my np435 swap than it would've cost for a correct t-18 by itself. Also, do not get the fsj t-18 without planning on swapping the input shaft.
10-07-2012 08:47 PM
jbhtn um, if you dont want it i will take it off your hands!
10-07-2012 08:35 PM
Cj7otr I was thinking the only T18 options for CJs were the T18 (4:1) or the T18-A (6:1). Maybe some full sized jeeps had T18-Bs?
10-07-2012 08:04 PM
Cj7otr It's about the best factory gearbox made. People spend big bucks getting those into their jeeps (trust me).
10-06-2012 06:30 PM
harleydragon in my opinion it is a lot tougher than anything you can get in a jeep these days..I ran one behind a 327 pulling 38 inch tires with 5.38 geared axles and never had any problem
10-06-2012 06:14 PM
Krazytrain
thoughts on a t-18 transmission

I have just bought a jeep project and it has a t18-1b transmission with the 6:32 low gear. What are your thoughts on this transmission? Pros vs Cons if any? I have been told that its a tuff transmission.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 11:18 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC