|11-30-2012 06:50 PM|
|dixau11||Use a bandsaw bud!^ and I think I'll just leave the lift on it. Someday I'll have a flawless jeep, but As of 19 and in college it will be a while|
|11-30-2012 09:44 AM|
|11-30-2012 06:54 AM|
|Wattapunk||By the time you pay for the hardware and tools needed, time measuring/cutting, it will cost almost for a new BL kit. I also wouldn't recommend reusing any parts from the old BL. Take it from a guy who tried to trim a hockey puck with a table saw for my 33" spare tire mount, I almost lost my thumb when the saw kickbacked and sliced my left thumb. I can't imaging a BL puck being any easier.|
|11-30-2012 12:40 AM|
Go to a specialty bolt store and get grade 8s that are the right length/size to replace the body mount ones that are going to be too long. you can find the right length by looking up a "whats included" for a 1.25 BL. Then use a table saw to cut down the pucks. That will make them the perfect length. And the radiators gonna be a *****. At least mine was. The stupid brackets are tough to get to and take frickin forever to remove.
Best of luck man
|11-29-2012 08:27 PM|
|Wattapunk||Be alot less time consuming and buy a JKS 1.25" BL that comes with new bolts, radiator supports and T-shifter bracket. If you don't want to mess with the bracket and radiator shroud, then now would be a good time to add an MML. You may have to shorten the fuel filler hose. Only jack up and work on one side at a time to prevent the tub from shifting. Jack up, remove the 3" pucks/bolts, insert the new ones and lower. Should be an easy swap. Why risk injury trying to cut down the pucks/bolts.|
|11-29-2012 04:08 PM|
|jameslee97206||Here's installation instructions for a 3 inch BL, see step 3 http://www.omix-ada.com/instructions/18303.11.pdf|
|11-29-2012 03:59 PM|
|11-29-2012 03:52 PM|
|dixau11||Picture of the bracket? And that link was to install... I don't think it's the opposite to remove exactly|
|11-29-2012 02:56 PM|
|jameslee97206||I would replace it with a new 1 to 1.25 inch body lift, comes with new bolts. There's a little more removing the 3 inch BL than the link enemy posted. There will be a bracket on the steering shaft that needs to be removed ( front driver side wheel well ), radiator will need to be adjusted as well as fuel filler hoses.|
|11-29-2012 02:49 PM|
Follow these steps.
Body Lift Install - Jeep Wrangler
As far as cutting them probably a bandsaw or something where you can get a perfectly straight cut.
|11-29-2012 02:42 PM|
How to remove a body lift?
So I have the dreaded 3" body lift.. I would like to cut them down to 2" or 1.75" any tips? What steps should I take In removing the mounts? I'm clueless. Just jack up the body?