Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ Tech Forum > u joint question.

Join Wrangler Forum Today


Thread: u joint question. Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
12-01-2012 01:34 PM
Trevor C 98tj Okay I'll check out when I get off work, thanks alot!
12-01-2012 01:19 PM
Jerry Bransford No, it should be as easy if not easier than before and no it will not loosen with use... at least not in a good way. It sounds to me like the bearing caps are simply binding against the bearing body, like they were seated too far inward aginst the u-joint trunion (body).

Remove the driveshaft and get your BFH (big effing hammer) out. Like a small one-handed sledge hammer. A normal hammer is not heavy enough for this job. Hold the driveshaft in one hand and use the BFH to smack the yoke holding the u-joint HARD so the enertia of the u-joint body can force the bearing cap outward back towards its clip. Flip the yoke around & do the same thing so the opposite bearing cap can be forced back out against its clip.

In other words... smacking the yoke with the BFH will cause the u-joint body to push the bearing cap nearest you towards you and outward toward its clip. Flip the yoke 180 and do it again. You are smacking the yoke right over where its bearing cap is. The hammer won't be able to actually touch or harm the bearing cap itself, the yoke will protect it. This should free it right up.
12-01-2012 01:17 PM
kfdjason7620 Nope, you might have had a needle bearing fall down when putting it together
12-01-2012 12:56 PM
Trevor C 98tj Just recently replaced my drive shaft u joint, is my first time replacing a u joint,then so, is the new joint suppost to be hard to turn when installed? The old one I could easily move the joint back and forth...

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 08:50 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC