|12-31-2012 12:07 PM|
Simple enough. You will need a clam shell type pulley puller. Do not use a fork type. The core is metal but the majority of it is plastic. Remove the lines from the pump, cover the lines with a platic bag and duct tape. This will keep yo grom losing all the fluid. Take the old pump off. Use the puller to pull the pulley. Use it again to install the pulley on the new pump. Install new pump. Re-connect lines. Top off start engine. Note level of fluid. Turn wheels from lock to lock a few times. Top off again if needed. Check system again after a few days to see if fluid level is satisfactory.
|12-30-2012 08:35 AM|
|dltucker77||Thanks for the info. I am going to check on a rebuilt pump tomorrow. How hard are they to replace yourself?|
|12-28-2012 02:47 PM|
degrease the area and lightly hose it off. The pump/steerign gear box, and anywhere the lines run. Air bubbles indicate a leak from somewhere, so you should see it on clean surfaces. It could be a loose hose, missing o-ring on a line, etc. If you cannot repair it yourself, I'd go somewhere else. If he isn't warranting his work (free) -he is either using bad parts or isn't very good at his job.
Power steering pumps require bleeding before you start the engine (same with replacing the steering box). If that pump runs dry for just a bit, it'll get ruined.
|12-28-2012 02:37 PM|
|dltucker77||I had a guy that worked on it. Not sure where he was getting the parts or what brand it was. Yes there are bubbles in the reservoir. I wouldnt even know where to begin on replacing one or installing an inline filter. I just keep filling it up and rolling on.|
|12-27-2012 10:29 PM|
|ESP||Are you replacing each time with OEM? Who is doing the work?|
|12-27-2012 10:14 PM|
|12-27-2012 09:00 PM|
|nwbronco||Where are you getting them from?|
|12-27-2012 07:43 PM|
|dltucker77||Thanks. Like I said, I am fixing to have to put # 4 on.|
|12-24-2012 03:24 PM|
I had the original fail. Got a re-built from NAPA. Holding up fine.
|12-24-2012 12:46 PM|
07 power stearing issues
I have gone through two PS pumps. Seems like my third is playing out. I constantly have to put fluid in it because it leaks down. Anyone else having or had issues? Any solutions?