|01-02-2013 04:21 PM|
|01-02-2013 12:01 PM|
|goodysgotacuda||You should also consider using marine grease if you like to play in water. "Normal" grease can almost wash completely away with water, marine grade is much more resistant to that.|
|01-02-2013 09:37 AM|
Stock JK ball joints are garbage. My Tj had 160k when I traded it in. Never touched the balljoints.
|01-02-2013 09:30 AM|
and i'm in the market for the ball joints myself... seems like 30K is about the cut off before they go in the tank...
|01-02-2013 09:22 AM|
|01-02-2013 09:17 AM|
How often are you lubing the ball joints, control arms, stuff like that? For my own education here...
|01-02-2013 08:42 AM|
|justcansin||good info ,Will be getting the ball joints replaced with synergy and get other lubes flushed,thanks|
|01-02-2013 05:17 AM|
Thanks for the advice.
Will be getting the ball joints replaced with synergy and get other lubes flushed
Installing the breather hoses is another thing on the increasing "to do" list
|01-01-2013 09:30 AM|
Also, Factory ball joints are Junque!! Do like Ken--- replace with Synergy ball joints--- definitely worth the cost. You won't be sorry you did any of these things.
|01-01-2013 09:20 AM|
My ball joints started to go at 40k
The bottoms were the worst. Factory Jk joints use a plastic sleeve the ball moves in. Wears out over time.
Aftermarket like my synergy are metal metal and are greasable.
|01-01-2013 09:16 AM|
|scubatech||I would feel safer pulling the carrier out and checking the bearing races for etching from the water being in there that long. Then I would flush it out good with brake parts cleaner just to be safe. It's not that big a job.|
|01-01-2013 09:08 AM|
|01-01-2013 06:13 AM|
What are the chances that I've done any damage given that I did @5000K with water in the diff.
|01-01-2013 06:06 AM|
I can't tell you much about the ball Joints other than some guys have them go out faster than others. Some one will have the full answer for you. But raising the breathers are a must if your doing any water crossings. Front diff, Transmission, & T case. Pulled up to be seen better.
|01-01-2013 05:55 AM|
Water in rear Diff - worn ball joints MY11
Took the jeep for a bit of a swim @3 months ago. Just had it in for a service and was told that there was quite a lot of water in the rear diff which likely came in through breather.
Is this a common problem and is it worth considering installing some breather hoses to a higher location.
I've probably done @5000k's since water entry. Is there anything I need to be concerned about now that the diff oil has been flushed and changed.
Also was told that there was quite a bit of wear in the ball joints and bushes in front diff, which need replacing. Jeep has done 38,000ks. 3" Lift kit kit went in @ 3months ago and 33"tyre @1 month ago. Is this normal that balljoints etc need replacing @ this time.
Thanks in advance