Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum > Weak pulling trailer

Join Wrangler Forum Today

Thread: Weak pulling trailer Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
01-03-2013 08:38 AM
kwn306 I have a 2005 LJ with a 4 spd auto and 6 cyl w/ 3.73 gears. The thing is terrible to tow with if I leave it in auto overdrive. It spends more time down shifting and the fuel mileage goes down to about 10.5 pulling 2 motorcycles on a small little trailer. If I take it out of overdrive and just let the 3 spd of the auto work I get 13.5 - 14 mpg and no down shifting. Me and the Jeep are much happier.
01-02-2013 01:56 PM
Bamadan I understand that but he said he would go to 33's which I believe would be the right choice now rather than regear again after the 33's. Not disagreeing that it's just a touch tall for present application but not that much.Also imo depends on what he uses his for too. I know it is irrelevant , but I drove a 66 chevelle that turned 3300 @ 60 mph.
01-02-2013 10:37 AM
Jerry Bransford
Originally Posted by Bamadan View Post
.410 would be my choice. That's just a good all round ratio for jeeps...
Remember, he has a 3-speed without an overdrive.
01-02-2013 10:34 AM
Bamadan .410 would be my choice. That's just a good all round ratio for jeeps. especially if future plans include 33's
01-01-2013 11:14 PM
Miser I just moved from the phoenix area to up on our Rim. From about 1800 ft elevation to about 7000 ft. I pulled a small mobile home that I am living in up some very steep grades for long duration. I believe that the trailer was a little over 4000 pounds. I know that it really made the Jeep squat in the rear. I have a dana 35 3:73 ratio with 31 inch tires, Automatic and 4.0 engine. I didn't know if the dana 35 would blow or what, but it handled it just fine with no failure. As for power, well it really struggled on them steep long mountainous roads. At times I could only get about 10 MPH out of it, but I made it there safe. The engine temperature went up to about 240 on the long grade pulls, it normally runs about 210.
These Jeeps just are not very good for towing. I guess that is why they rate them for 2000 pounds max towing.
01-01-2013 10:00 PM
WVU Mountainman Thank you!
01-01-2013 09:26 PM
Jerry Bransford 4.10 with 31" tires would just give a higher highway engine rpm but that wouldn't be bad for anything other than mpg. I drove my TJ with 4.88 gearing & 35" tires for several years after converting from its OE 5-speed to the 32RH which gave similar RPMs to what 4.10 would with 31" tires.
01-01-2013 09:17 PM
WVU Mountainman Thanks Jerry. What would 4.10's do with the 31's if I change now and eventually upgrade to 33's
01-01-2013 09:09 PM
Jerry Bransford Yes regearing will help and is the answer. Your 3.07 gearing isn't helping one bit, in fact that gear ratio is producing significantly lower power than 3.73 would. If you plan to tow much, I'd regear away from that 3.07 to a lower ratio like 3.73 to improve your power. Do you think you might ever go to a larger tire size like 33"? If so, 4.10 would be a good ratio to regear to.
01-01-2013 09:05 PM
WVU Mountainman
Weak pulling trailer

2000 TJ Automatic. 3.07 gears. Stock suspension 31x10.50's. Pulling my foreman fourtrax 500 and a 4x8 steel trailer with sides, the jeep lugs down on hills. If I floor the gas it downshifts but immediately up shifts. Would a regear help this issue? I do NOT plan to lift in the future.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 12:37 PM.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC. is not in any way associated with the Chrysler Motors LLC