|01-03-2013 04:13 PM|
|09rubakon||Thanks that helped to better understand the intermitancy problem. I thought once the cel came on it had to be cleared in order to go off. I will continue looking into the possible fuel issue. Thanks|
|01-03-2013 03:13 AM|
A couple of things I found on another site:
The second one, I'm kind of leary of in this instance since P0138 is 1st bank 2nd sensor and P0158 is 2nd bank 2nd sensor. I'm not 100% sure but I don't think that the sensors share a common path to the PCM, i.e. each reports independently to the PCM via its own path and it would seem unlikely, to me at least, that each path would short to battery intermitantly. One easy way to check would be to disconnect the harness from each sensor and check for power without the key on. If it is shorted to battery voltage, you should see ~12V at the connector.
The third one seems a little more likely to set intermitant codes in both sensors since an over rich condition would be seen by the entire system and could, in theory, be intermitant if the fuel system is surging for some reason.
As to why the light comes on for a few days and then goes off, the computer will clear some codes after a certain number of good run cycles so the code may be cleared one day only to be reset on the next.
|01-02-2013 08:16 PM|
Why does it come and go?
Hi, recently got an 09 rubicon 4 door auto trans w/ 77,000, the cel is on and calls for codes po138 & po158, however the light comes on for a few days then off, changed the sensors nothing. Dealer said it had a new cat. put in checked all the exhaust that seems gd. Going to work my way through the wires next. Any other ideas before I dig in, possibly a faulty PCM or expasion tank problem? Thanks for any ideas!