|12-17-2013 03:36 AM|
|01-TJ||congrats on the jeep|
|12-17-2013 02:59 AM|
|TJXFREAK||11.12.13 some people got married, some had kids, i went bought my first wrangler 4.0L 5spd.|
|01-10-2013 06:38 AM|
|01-09-2013 11:35 PM|
|Ebxgsxr||holy old posts batman....this is from 2009.|
|01-09-2013 11:04 PM|
|K.wag||but I just noticed you talked about the links being parallel too... my bad. haha. i had a front trackbar bracket installed to keep them parallel. those have to go together.|
|01-09-2013 11:02 PM|
so a drop pitman arm actually decreases death wobble, but increases bump steer. Ill take the bump steer over death wobble anyday. heck im used to it now.
|01-09-2013 10:52 PM|
|kevcon||Nice jeep I only had to adjust the drag link on mine to center the steering wheel after setting the toe in after installing the lift.|
|01-09-2013 09:40 PM|
J ust E mpty E every P ocket
Sweet! Congrats, My wife and I own 2, 1989 YJ Sahara & 2004 Unlimited. I think the more the marrier. My goel is to own 1 of every type MB too what ever they come up with next.
|04-05-2012 11:14 AM|
I just checked out Kentucky law on the need for a left side mirror at the link below, it is a law to have one in Kentucky,, so check the link for your state, you may be in violation when the doors are removed.
Main Page - EcoModder
|04-05-2012 11:01 AM|
Oh you poor bugger, you just lost your freedom, you are now a Jeep Slave.
|10-22-2009 02:04 AM|
Nicolas-Eric nailed it Rico334, the previous owner installed a dropped Pitman arm when a stock upper trackbar mount is still being used... a BIG no-no where a TJ is concerned. That causes bump steer which is where the steering is forced left/right as the front suspension moves up and down over bumps/dips in the road.
You really need to have an OE (factory) Pitman arm reinstalled and get rid of that dropped Pitman arm. Once done, your steering will immediately be MUCH better and you will no longer have bump steer. Many owners of Jeeps that have bump steer have no idea they have bump steer and just assume it's supposed to feel that way going over bumps or dips in the road.... it's not.
|10-21-2009 11:41 PM|
|rico334||I'll definately get it in for an alignment and thanks for your help !!! Hopefully this Jerry Bransford may lend some advice of what I have or more so, what else I may need differently ... Thanks again !!!!!|
|10-21-2009 11:39 PM|
Thatīs the stock track bar mount position.
IMO you have a dropped pitman arm. With that the drag-link and the tie rod areīt parallel anymore what could cause some problems.
Perhaps somebody with a better knowledge should take a look at your pics, like Jerry Bransford..
Regardless of that you should make a front alignment. When itīs off the tires wil wear faster.
|10-21-2009 11:25 PM|
nicholas-eric, here is another shot of where the trackbar attaches to the axle. It can be seen just under the shock absorber and attaches to the bottom of the bracket that the absorber attaches to, which is all attached to the front axle.
|10-21-2009 11:15 PM|
|Schmo||Sounds to me like she didn't get an alignment after she had the lift installed which is REQUIRED. Hurry up and do it quick or those nice new tires won't be so nice for long, but would be a good excuse to upgrade to 33's which would fit nicely under a 4" lift!|
|10-21-2009 11:11 PM|
That pitman arm looks bigger to me than the pitma arm on the pic I postet before.
Please look at my pic above again. How is your track bar attached to the axle?
She said that the steering wheel was off afgter installing the lift? Then you should do a complete front alignment like in the write-up link I postet before. After installing a lift the tow-in is off. That has to be corrected.
|10-21-2009 11:05 PM|
Here's a couple of pics of what's under there. Don't know if this will tell you anything about what may be installed, she just told me the wheel was like that after they got through putting the lift on it......
|10-21-2009 10:58 PM|
Btw. nice looking Jeep !
The tires look a bit small. But Iīm sure that will change in the next weeks/months.
|10-21-2009 10:57 PM|
|litespeed||What an awesome ride and what awesome lotto style luck.This will be your Jeep 4 life.|
|10-21-2009 10:54 PM|
If there is a rubber plug, itīs a D35 rear axle. Thatīs weaker tha the D44.
What did the do with the steering linkage? Did they install a dropped pitman arm? If yes: Thatīs not needed and wil cause some problems like death wobble.
To center the steering wheel you have to turnaround the thing with teh 2 clamps on it at the tie-rod (loosen the clamps before).
Hereīs a good write-up: Basic Jeep Front End Alignment
|10-21-2009 10:53 PM|
Thats the Dana 35
That what most have but
of coarse the 44 is more heavy duty
Standard on the rubi,option on others
Stick around here there is alot to learn
|10-21-2009 10:46 PM|
|rico334||Birdhunter, I'm about to exhibit my ignorance in the jeep world. I've heard of the Dana 44 rear ends, but don't know anymore about what one my do over another, but just went out and checked and don't see a metal plug, instead about halfway up on the backside of the rearend, it looks like a black plastic or rubber plug of some sort ? ? ? ?|
|10-21-2009 10:29 PM|
I think you have to remove steering wheel/
I would just live with it
Great deal does it have the 44 rear end?
metal fill plug
Nice Ride have fun get it dirty
|10-21-2009 10:29 PM|
|JDsDream||What a deal, congrats.|
|10-21-2009 10:17 PM|
Officially a JEEP owner today
Stole this little jewel today. Ran into a girl Monday that desperately needed out of this '05 "X" model wrangler, 6sp 6cyl with 19k on the clock. Only 800 miles ago, she had a 4" lift installed along with 5 new rims and 5 new BF Goodrich 31's.
Had no clue what one was worth so went to my credit union and had the lender book it for me. Retail was $17,250 and loan was $15,200. I drove it home today with a clear title in hand for $11,000 ......
Now I have a question about it. I suppose it's from the lift being installed, she said they had to add something to steering linkage ( ? ? ? ), anyhow, the steering wheel sits cockeyed now, what should be the top of the wheel with the jeep logo in the center, is now turned about 1/4 turn to the left when the wheels are pointed straight.
What's up with this and how can it be remedied ? Just looks funny driving straight down the road with the steering wheel turned off center like that.