Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum > My CB Install Project

Join Wrangler Forum Today

Thread: My CB Install Project Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
01-10-2013 10:31 PM
friedfish Looks like my setup. I made mine out of some erector set I had laying around. I need to add a center support to keep the bar from twisting on the poopy Illinois roads. I have allready expanded on it and added my siren box over the drivers seat since the pic.

Attachment 196729
01-10-2013 09:36 PM
Water Dog Thanks guys. I don't use door surrounds so didn't need to worry about that, but I still needed to be able to unbolt this fairly easily to shift it back enough to get the hardtop latches to release. Only need to do that twice a year though.
01-10-2013 08:38 PM
Patrick H Looks good. I almost went that route, but decided to mount it to the W/S frame so as not to interfere with my door surrounds when I run the soft tops. I can still use the footman loop as well.

Nice work!
01-10-2013 08:35 PM
Coastiejeep Looks good
01-10-2013 07:55 PM
Water Dog More pics
01-10-2013 07:54 PM
Water Dog
My CB Install Project

After seeing the install of another members overhead CB Radio, I decided something like that would work for me. My goal was to try to keep mine slightly lower for two reasons. The first one is that I didn't want to have to try and find a way to finish raw ends above the roll bar, and secondly, and more important, I use a spiderweb shade top all spring and summer. I still wanted that to be able to be flat across the top and wanted access to the front center footman loop to tie it to.

I chose to use a length of 1" x 2" x 1/8" wall aluminum rectangular tubing. I found an 8' length at our local "Blue Collar Supply" store for $30. Nice thing about aluminum, is that I can work on it with my woodworking tools. I cut it to length, then used my band saw to shape the ends to fit the roll bar on each side. I drilled a 15/32 hole on each end that a 3/8 x 16 T-nut (without prongs) would drop into and used the same bit to slightly enlarge the existing holes in the roll bar. A 3/8 x 2" Allen Head Stainless Steel bolt was then used up from the bottom of the roll bar. This left a pretty finished surface on both top and bottom. Wound up being very solid. A little satin black Krylon and it's pretty much done except running the wires...another day. Here's some pics.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 06:26 PM.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC. is not in any way associated with the Chrysler Motors LLC