|05-13-2013 10:05 AM|
|TJX02||Mrsig, how did you go about mounting that Aux fuse box? I have the same one and was looking at where/how to mount it in the hood and your set up looks really clean. I may have to steal with pride......|
|01-21-2013 10:16 PM|
|mikeym||I love it, the color and texture is spot on, and unless you knew it was after market, you'd never know. Mine is also a manual, so I almost had to go that route. You can buy the same panel, loaded with switches, or do what I did and buy switches at radio shack. I do want to get a relay box like the guy above has, just haven't gotten around to it|
|01-21-2013 10:00 PM|
|nicovalencia||Thanks for all the great replies! I'm torn between the spod panel (looks really nice) and the other type that mounts under the HVAC controls. I have a manual, so I'm not sure the lower panel will fit, and I have a Tuffy overhead console so I'm not sure that the spod switch panel will fit up top in the middle (first world problems). Is there any way to run it on the side? mikeym you have a pretty cool side panel - how do you like it?|
|01-21-2013 05:51 PM|
|01-21-2013 05:36 PM|
Here's what I did on mine, very similar to the above
|01-21-2013 08:18 AM|
Update: when looking at the circuit diagram on bluesea's site, it show's only one feed.
|01-21-2013 07:59 AM|
Here's link to Sig's fuse block. Browsing Store - 12 CIRCT FUSE BLOCK W/GRD
Here is same thing on Amazon. http://www.amazon.com/Blue-Sea-Syste...rds=fuse+block
Anyone know how you might get half of these constant power and half ignition switched power? Thinking you would have to go with 2 of them.
|01-21-2013 06:51 AM|
Here's the switch panel that comes with the spod for reference. Perfect fit between sun visors, looks really clean. You can get different colors or combinations if colors but I liked the all blue look. You can turn these on and run accessories with the engine off - it will shut its self off when battery gets to a certain point so that you have enough juice to start again.
|01-21-2013 04:28 AM|
I got it from Boat Owners Warehouse it is like a west marine but cheaper and I have it ran to a bunch of switches on my Daystar panel and dash.
|01-20-2013 10:53 PM|
|01-20-2013 10:00 AM|
That's neat looking Sig. I'd like more info as well.
I'm going to start adding items soon but I'd like to not go with the sPod. I just can't justify the expense for it.
|01-20-2013 07:45 AM|
|01-20-2013 05:04 AM|
I went a cheaper way than the SPOD. Been working great for over 2 years now.
|01-19-2013 08:25 PM|
Get a spod, it's awesome. A little pricey but extremely well made...and made in USA. I just installed one, I love it.
4x4 SPOD Since 2005 - The ORIGINAL JEEP Over The Windshield Switch Console - Jeep Power Distribution System
|01-19-2013 05:41 PM|
Aux Fuse Block and switch wiring
Used to be an old jeepforum member, and just got over to WranglerForum via my brother's advice.
I just got a new bumper and the delta fog lights. They seem to be higher wattage than the stock fogs, and instead of using a relay from my factory fog light wiring, I'd kinda like to run a separate line.
I've installed a couple other mods for speakers and additional lights, so my battery is starting to get a bit crazy looking. What is the best way you guys have seen extending a fuse block or battery range and integrating additional switches?
I did some searching, but most questions were more specific rather than general strategies. Please shout out another thread if I missed one that already exists!