Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ Tech Forum > Ignition/coil/ICM question....engine quits

Join Wrangler Forum Today


Thread: Ignition/coil/ICM question....engine quits Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
01-23-2013 04:37 PM
Surinamer My problem turned out to be a loose wire, shorting out.
12-05-2012 02:39 PM
Surinamer
same problem - 6 years later

Hi, having the same problem w/ 2006 Wrangler Unlimited. Did the ICM fix the problem for good? That might be our problem too.
01-16-2007 03:26 PM
biblicone After that I put in a Weber Carb. Now it idles great.
12-30-2006 02:59 PM
Greatwhite Yup, swapped out the ICM, and it is doing well so far.... THX for the verification!!
12-30-2006 02:55 PM
biblicone I had a similar problem (occasional starts...) and it was the Ignition Control Module. It is on the expensive side ($100 at autozone), but when the Jeep starts right up its worth it.
12-12-2006 07:07 PM
NY94YJ Pretty sure the Coil is Good or No Good. (been there....cut out while driving..not to be restarted.)

Not sure about ignition module.

YES a "dirty", corroded, bad, electrical connection can be intermitent.
12-11-2006 10:01 PM
Greatwhite
Ignition/coil/ICM question....engine quits

Hey gang,

A week ago, while cruising at 45mph, the engine quit for about 5 seconds, dead...no response, and tach at zero. then just as suddenly, tach came back up and drove fine....perfectly.

This week it won't start one day in the garage at home, but then an hour later fires right up.

Yesterday drove to the grocery store and it won't start on leaving....plenty of fuel, but no spark as confirmed pulling a wire while cranking....

I got a tow home, and checked the wires to the coil for security, they were all tight, but after checking, on a whim I tried to start and it fired right up.

Removed the coil, did some resistance checks on it...passed.

I am hearing, and leaning toward an Ignition Control Module as the culprit....

QUESTIONS for the tech gurus':

Can a coil be intermittent, or is it a good/no good issue?

Can an ignition module be intermittent?

Can a dirty (not broken) wire be touchy enough to cause lack of power to coil?

Advice? Ideas?

I am loving the jeep for putting around, but at this point losing alot of faith in its dependability....tinkering and maintenance is normal, I understand, but being stranded is another issue....

THX

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 08:17 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC