|12-17-2014 12:49 PM|
Going to contact check Corp directly today to see if they can help as they are nearby, I now regret not calling them in the first place.. ugh very annoyed. Rule #1 on the Web is to be accurate about what you're selling, and that clearly isn't the case here.
If all else fails I'll return them and look into the mopar kit 82212697 as it appears to be 2 full seat kits of 4 heaters. (But more money)
|12-17-2014 12:39 PM|
|RB-10rubicon||If your not getting four heating elements.i would order a set for a earleir year 07-10 .i just ordered a set for my sisters jeep and it has four elements.the kit works the same its basically universal you could intall them in any vehicle.i would think they ask you vehicle specific for the size of the heating elementshttp://www.checkcorp.com/seat-heater/seat-heaters.asp|
|12-17-2014 12:03 AM|
i just did the Check Corp heaters for 2012+ (in a 2015 JKU-s if that matters) no heater for the passenger side bottom. And no complaints either.
round switches installed in the center console under the latch..
Its a mild PITA install with the dash+ , seats, center console all coming out. But plug and play and routing wires install.
|12-16-2014 07:33 PM|
what kit did you use?
|10-16-2014 02:24 PM|
Good to know. If that's the case I may have to look into it, but I can't imagine the liability involved if you were in an accident and the airbag didn't go off, or went off when it shouldn't have, and they found out the occupancy sensor had been tampered with.
Assuming it's in the center it's too bad someone hasn't come out with a kit that has smaller strips that plug in independently so you don't have to cover the whole bottom, but rather could cover little runway sections on the left and right side and not have them connected.
|10-16-2014 01:45 PM|
I installed Check seat covers on both seats in my 2012 JKUR (when all I could find was "this won't work" for the same reasons noted above). Yes, there is a sensor in the passenger seat. I gently removed it from the foam and replaced it on top of the heating pad. So far, I have had no issues with the sensor not properly identifying a passenger in the seat.
Unless they have changed the sensor mounting on 2013, I suspect it will work. Only real way to know is to pull the seat and cover and take a look. Mounting over seats and under covers is another good option.
I blatantly ripped off another installers idea and put rocker switches in front of cup holders. Looks almost like the factory put them there.
Hope this is somewhat helpful.
|10-16-2014 12:20 PM|
|wassup8687||I have a 2012 and installed seat covers. I just put them over the stock seats and under my TREK Armor seat covers. They've been working great.|
|10-16-2014 09:51 AM|
|siggyfreud||I just did my 2014 seats using a universal Dorman kit. I did the full drivers seat, and then the back only on the passenger seat. I didn't pull up the passenger cover on the seat part to see what was going on, just assumed a heater wouldn't fit. One day I might pull it and see what's what.|
|10-16-2014 09:31 AM|
|12-24-2013 06:10 PM|
|mello03||Any update on this? I really wish someone would come out with something for the passengers seat.....|
|12-04-2013 07:54 AM|
|12-03-2013 02:59 PM|
|12-03-2013 01:44 PM|
|12-03-2013 10:30 AM|
|12-03-2013 10:03 AM|
I had the installer who did Katzkins put in W.E.T. Seat heaters in my last jeep. There were back and bottom for both seats. I watched them install them and it wasn't too bad of an install. They were the carbon fiber kind, and they wired them into the fuse block in the factory seat heater spot.
I never had an issue with the OCS system in my last Wrangler.
|12-03-2013 09:45 AM|
|Randolph||I installed a WarmSeats seat heater into a '13 Sport S with cloth seats. I've had it switched on 98% of the time since then - not since Susan Donatio in the seventh grade have my balls been so happy.|
|12-03-2013 12:15 AM|
I'll admit failure.
I ordered the Dorman seat heater ($70 per seat on Amazon). I bench tested it (6.5 amps on high, about 2.0 amps on low) then I pulled the seat out of a '13 JKU sport. (easy with an impact gun, gotta use a Torx for the seat belt).
Put the seat on a workbench and started to pull the cover. Unlike earlier models, this seat is fitted with 3 rods down the length of the seat and the approx. 10" square element wont fit without getting it's center crunched.
So after 10 minutes I decided to put the seat back in and watch Sportscenter. I'll probably put this in my '10 (looks doable).
Someone probably makes an aftermarket element for this seat, I just haven't seen it.
|11-24-2013 09:56 AM|
2) where did you get these switches they are friggin awesome!
|11-21-2013 08:20 PM|
|11-21-2013 05:47 PM|
|rubisteph||My brother got a set from ebay and installed them in his rear seats for the kids.... he put the swithes behind the center console.... looks almost stock and work great.... I'm contemplating doing the same in my 10A....|
|11-21-2013 05:23 PM|
When I installed these I had one vehicle the TJ, and I averaged almost 300 miles a week...of which probably 230 were highway..things have changed a lot now, and the TJ if I am lucky only gets about 100 miles per week unless I go Wheeling. So the last time I had the seat covers off I pulled the heater pads out and most of the wiring...when life gets back to normal, but not so busy that I can take the time to work on the TJ maybe I will trouble shoot the switch and wiring......hope this helps? Good Luck!!!
|11-21-2013 04:55 PM|
|Kiriesh||Does anybody worry about these if they get wet? I have seat covers and was thinking of just slipping them between the seat and the cover but its a jeep so its going to get wet and I'd prefer not to start an electrical fire.|
|11-21-2013 03:58 PM|
|11-21-2013 03:34 PM|
My '14 JKUR DD has heated seats. Some other family members are envious, so I need a plan.
|11-21-2013 02:43 PM|
This is what Santa is bringing me....Amazon.com: Dorman 628-040 Universal Seat Heater Kit: Automotive
Already has the cutouts for the listings and I don't think covering the occupant sensor will be an issue....
|11-21-2013 02:19 PM|
|jp2611||FWIW there are seat heaters for the '14s....but IDK if it is aftermarket...our'14 came from the factory with seat heaters.|
|11-21-2013 02:07 PM|
This is cheaper
ACE Engineering Lava Jacket
|11-21-2013 01:57 PM|
|5JKs||Bump, I want to put a seat heater in driver's side of a 2013 JKU. Anyone done this?|
|09-25-2013 11:29 AM|
|Crewski||Bringing back an old thread.....but were any aftermarket seat heaters developed for '13-'14 seats? I have a '14 and winter is right around the corner.|
|02-05-2013 09:40 AM|
WAS GOING TO START INSTALL OF HEATED SEATS TO 2013 JEEP WRANGLER TODAY. AFTER READING MORE ON FORUM CONTACTED STEVE WHITES MOTOR WHERE I PURCHASED HEATED SEATS. ASKED FOR CLARIFICATION ONCE AGAIN THAT THEY FIT 2013. REPLY WAS "NO" SO I HAVE STOPPED AND ARE RETURNING PART NUMBER 82212697 AS THEY DO NOT FIT 2013. THANKS FOR ALL THE HELP WILL BE WAITING LIKE OTHER 2013 OWNERS FOR NEW KIT
|This thread has more than 30 replies. Click here to review the whole thread.|