|Today 12:32 AM|
|Today 12:01 AM|
|chrlswltrs||And my JVC stereo head unit from the wife|
|Today 12:00 AM|
|chrlswltrs||Installed my Christmas gifts. Rugged Ridge steel grill insert from my daughter|
|Yesterday 11:53 PM|
|ThePoohmeister||Trimmed my stock bumper into stubby, installed ACE Rock Rails, and ordered the Rugged Ridge Performance Hood|
|Yesterday 11:35 PM|
|Yesterday 11:01 PM|
|Yesterday 10:41 PM|
|MJRob||Finally got my bumper and light bar installed. Been waiting for the past 4 months, first on poison spider to make the bumper and to receive the light in the mail then on the powder coater. But it was worth it.|
|Yesterday 09:47 PM|
2.5 X Factor lift with OME steering stabilizer, Adams front drive shaft and Bilstein 5100s, 35 Duratracs on stock rims, ACE Pro Series front stubby with bull bar and ACE rear bumper with tire carrier. Backup camera and lockpick air. Having a blast with it.
|Yesterday 09:26 PM|
|Red Rock Raider|
|Yesterday 09:23 PM|
|Yesterday 08:45 PM|
|Yesterday 07:03 PM|
|Red Rock Raider||
Installed my Tuffy rear enclosure and did a cheap mod by add some non-skid material to the top surface.
Hopefully tomorrow I will be installing my Rancho front control arm drop brackets. Next week the Teraflex rear tire carrier.......woohoo!
|Yesterday 06:45 PM|
|wrath0r||^^ Love the Mass Effect swag! I had a custom N7 tire cover for a while.|
|Yesterday 06:42 PM|
2.5" aev lift, 17" worx beast 803 rims, 35" duratracs, adjustable front track bar, jks quick discos
|Yesterday 06:29 PM|
|Yesterday 06:21 PM|
Not today, but yesterday.. Ordered
Metalcloak 2.5" gamechanger lite
Poison spyder brawler II rear bumper/tire
Carrier & upgraded trans crossmember
Quadratec 17x9 gunmetal bajas
I can't wait for to have all of it installed!!
|Yesterday 06:19 PM|
|wanderer1951||Installed Barricade Enhanced Rubi Rails on the JK..Actually it was last weekend,, Was a quick easy install.|
|Yesterday 05:57 PM|
|Yesterday 03:29 PM|
Put the PSC Bombshell dana 44 diff covers on today!
|Yesterday 01:43 PM|
Drove home for Christmas,
While letting the dog sleep,
Attempted to make paracord grab handles,[/URL
Have a great Christmas everyone!
|Yesterday 12:26 PM|
|Yesterday 11:16 AM|
|Yesterday 09:14 AM|
First one is mounted and you can see they are quite small...and shameless GSD promotion.
Second is reverse only...and this is after I swapped to V-LED rears or SuperLed. Can't remember which exactly...still not happy.
Third is with reverse and aux lights on and then head on (for what it's worth?)
Cost outside of the lights was a on-off-on switch ($12) and relay ($6), already have plenty of wire and connectors. I also already had the daystar panel for this and other stuff.
Just my two bits, the fit of the daystar is sub-par in my opinion. The distance between the red lines is too large and the top clips don't line up. I notched the tabs on the bottom between 1/4" and 3/8" to get the panel to drop further for the tabs to drop in. Even then, the panel is almost flat if not bowed a little in the wrong direction causing the clips to either not hold or the edges to curl out. I just drilled the corners on the panel and sunk two screws with some plastic screw covers from HD.
|Yesterday 07:46 AM|
|All Terrain JK|
|Yesterday 06:49 AM|
|Yesterday 02:29 AM|
|WTON||Christmas came early! Installed TJM rock krawler stubby and recon synthetic winch. Super pumped! Big thanks to MikeJKUR and GoBig19 for the electrical guidance.|
|Yesterday 02:19 AM|
|Yesterday 02:09 AM|
|Yesterday 01:54 AM|
|OUTAGAS||Ordered a pair of trucklites (to replace my Cibie H4) from Rebel Off road for $319.99 incl. S/H. And got a 5 tire rot at DT.|
|Yesterday 01:09 AM|
|This thread has more than 30 replies. Click here to review the whole thread.|