|02-07-2013 09:26 AM|
|Rrampley||Just the clip part is broken off both side the base is there as well as the little pins that hold the clip on to the base.|
|02-07-2013 09:09 AM|
What part are you missing, the clip (arm), the base, or the whole damn thing?
|02-06-2013 11:37 PM|
|Rrampley||But what if there is no clip to take off?|
|02-06-2013 09:28 PM|
Hey guys I have experience with this as I fixed my sliders right after I bought my jeep last month. First off, bestop upper door sliders, clips were essentially useless and would pop out over bumps.
To remove them you need a torx bit with a hole in the center (tamper proof torx). You can get around this by getting a set of clamping pliers on there and turning the two bolts off. Be careful not to break or scratch the window, but it should be alright. Once you got the clip off you need to separate the two pieces. Push in on both ends of the "pins" and pull the clip from the base. Once apart yu will see there is NO spring!? Mine had a simple piece of plastic that was broken to the point where it did nothing. My fix was to buy 4 springs (1 per clip), and install them into the base. Put the clip back onto the base and reinstall.
Hope this helps, I can try to go into more detail if needed, but really it's self explanatory once you get them off and open them up.
|02-06-2013 09:06 PM|
|Rrampley||They were Best Top sliders the whole set upper doors. No parts for them I could find.|
|02-06-2013 08:38 PM|
|All Terrain TJ|
|02-06-2013 07:34 PM|
|Rrampley||On mine the clip portion is broken off. Has been since I got the jeep last march...|
|02-06-2013 07:09 PM|
just take them apart . They have a small piece of flat spring steel that if you just flip it over will work like new again.
If they are like mine and i am sure they are.
|02-06-2013 06:43 PM|
|Rrampley||On my latches on the slider window they say STEEL HORSE so I looked online and can't find any parts just the doors that sell for about $450 a set.|
|02-06-2013 06:26 PM|
|TheDefiled||Same issue the front part will be fine but the back slider always opens and can easily slide it open to get into my jeep. A cheap way to fix it would be to duct tape it, but if there's a more permanent to open it that'd be better.|
|02-06-2013 06:24 PM|
|Rrampley||X3 I need the latch locks for my sliders also|
|02-06-2013 06:18 PM|
|Grizzly74||Ive got the same issue with a 1997 TJ...so if anyone can clue me into where you can get the 4 locks. It would be greatly apprecited!|
|10-12-2011 12:20 PM|
Sliding window locks
Before I take them off and apart to replace what I assume is springs? Is it easier to just buy new ones and if so where? Mine won't stay closed and the windows slide open when driving.