|02-18-2013 04:07 PM|
|02-18-2013 12:51 PM|
Thanks for the heads up andrew127.
I looked around, or should I say climbed around, my engine and it seems the valve cover is the culprit at this point. There's plenty or "moisture" around the edge, especially in the back. I'm gonna try to re-torque the bolts today to see if that helps. If not I'll gasket it at my earliest convenience.
|02-17-2013 07:37 AM|
Yes the valve cover is also known as the cylinder head cover. If you are going to put a new gasket on it I would suggest not buying a replacement gasket, but getting a silcone gasket maker. They are cheaper then factory gasket material and you can put a good amount on. The stuff I use at my shop is called The Right Stuff by Permatex, a little bit pricier than most but as with anything you get what you pay for.
|02-16-2013 10:49 PM|
Thanks, that's what I thought. I'll look for the write up tomorrow, the android search is crappy at best.
When you say the valve cover, would that be the cylinder head cover?
|02-16-2013 09:10 PM|
|doclouie||Yep it is a common 4.0 problem. It requires a rear main seal replacement as long as it is not coming from the valve cover and dripping down. There are lots of write ups on how to do it, but check out Stu's site as it is one of the best.|
|02-16-2013 08:34 PM|
Rear Engine Gasket leak?
I read around here about a rear gasket leak common on the TJs. I was working on unrelated things when I came across this.
Is that the common leak? And if so how do I fix it?
Also, there's supposed to be a bolt there in the middle correct?