|02-22-2013 06:21 PM|
|Hansen||Got the answer from PIAA tech support. The black wire serves only as a ground wire for the LED on the switch. Otherwise, no other function and not need. Just use the white/red wire coming out of the relay to connect to the highbeam wire.|
|02-22-2013 05:00 PM|
|02-22-2013 04:35 PM|
|kyvtx1300||No soldering everything together, you have a ground in that switch too. And the high beam is CANBUS, so your relay is not going to like it unless you install a cap on the line triggering the relay.|
|02-22-2013 04:00 PM|
Wiring PIAA lights
I'm installing some PIAA 520 lights on my bumper this weekend. PIAA's wire harness comes pre-made with the relay wired into it and a switch incorporated into the harness. I don't want to use the switch (or any switch) as I'll be triggering the lights off the high beam wire via the relay. A copy of PIAA's wiring diagram is attached. I'd like to get rid of the switch you see in the diagram so I don't have that mess stuff into the engine compartment (I recognize I could leave it attached and in the on position in the engine compartment but prefer not to do that). So, my question: how do I get rid of the switch completely...meanign what wires do I tie together?
If I'm reading the diagram right, I think I just cut that plug off (#3 on diagram) and solder all three of those wires together?