|03-02-2013 04:23 PM|
|03-02-2013 03:57 PM|
|NFRs2000NYC||Thanks for the tip. Took 15 minutes using the driver's side. MUCH MUCH easier.|
|03-02-2013 02:32 PM|
|03-02-2013 01:56 PM|
|03-02-2013 12:39 PM|
|03-02-2013 12:13 PM|
Here is a couple images from my write-up http://www.wranglerforum.com/f33/ext...se-185089.html
I used the yellow strap to feed it through first. Then I tied that to the hose to pull it through. It comes out behind the plastic wheel well. You might have to pry it back a bit to see it. Then you can pull it over to right where you want it where the factory one ends.
You can also check out this video at 1:30 and it shows it installed.
Breather Hose Locations 2012 Manual JK Wrangler - YouTube
|03-02-2013 11:41 AM|
|03-02-2013 06:06 AM|
There is a plate to the rear of the body where the light mounts on.
Go over the top, you have to look up inside the opening, and down from there and it comes out the bottom in front of where the foam stuff is at a small triangular shaped hole in the body.
|03-02-2013 12:49 AM|
|03-02-2013 12:18 AM|
|03-01-2013 09:57 PM|
I routed the hose up from the bottom- ended up coming out here. pic is looking straight in through the passenger tail light opening.
2013 Rubi JK
Hope that helps.
|03-01-2013 09:14 PM|
|03-01-2013 08:07 PM|
|SilverSport||Route it to the driver's side taillight cavity.|
|03-01-2013 08:05 PM|
Extending the rear axle breather help...
Hey guys, I saw all the threads, and was planning on moving my breather to inside the cavity behind the tailight. However, after taking the light off, I noticed there was no way to get to the outside of the Jeep through there. I don't know how other years were, but on a 2012, the base of the cavity is filled with foam and I couldn't see any way to get the breather up there. I also REALLY REALLY don't want to route the rear breather to the front. So, anyone had a good location to route the rear breather to on the REAR of the Jeep?