|12-03-2006 01:55 PM|
|Triple88a||i twisted them back so i can get the bar pointing down.. so nope they were far away..|
|12-03-2006 12:10 PM|
|khenderson||was the sway bar still able to touch the links, since you left them pointing up? might try cranking them away from the bar just to make absolutely sure that's not it.|
|12-03-2006 12:07 PM|
|Triple88a||so i took off the swaybar links and i do notice the extra body roll.. it seems that the noise is a bit louder now I couldnt get the lower bolts loose on the links but i got both top bolts loose and removed the bar so now the bar is just hanging down while the links are still pointing upwards. It raddlles even more now. I'm new to jeep so i dont know for sure but from my car world this would lead to control arm bushings..|
|12-03-2006 11:11 AM|
|12-03-2006 10:58 AM|
|12-03-2006 10:48 AM|
|Triple88a||Thanks Cliff after my breakfast ill run downstairs and remove the stocks and hope for the best.. if broken (hopefully) i will go with the jks'|
|12-03-2006 08:53 AM|
I like JKS. They don't rattle and are adjustable with your specific lift.
I run these on my wifes jeep. My jeep is setup with a Currie Anti Rock
|12-03-2006 02:44 AM|
|Triple88a||Thanks. Ill take them off tomorow and hope it doesnt rattle any more and perhaps proving that this is the problem...|
|12-02-2006 06:54 PM|
|khenderson||that would help narrow the search if it isn't your endlinks that are rattling. one of my end links broke a few years back and i just took it off and never got around to replacing or upgrading, so i ended up just taking my whole sway bar off.|
|12-02-2006 06:21 PM|
|Triple88a||so khenderson you are saying to disconnect the links at all and see if its rattling again?|
|12-02-2006 06:04 PM|
what are these things you guys are talking about!?! sway bar end links?! huh??
i've been running swaybar-less for a little over 2 years now. and since I've never had any problems running without it, it'll stay that way until my jeep gets much bigger. so that's always an option as well.
but jks and re are probly the brands i've seen/heard alot of guys using.
|12-02-2006 05:42 PM|
|Triple88a||so today i went to my jeep dealer and the guy that sold me my car told me its gotta be the swaybar links that are rattling on mine as well.. they look kinda crooket on top so he says its the links.. which aftermarket do you guys reccomend?|
|12-02-2006 02:43 PM|
|11-29-2006 09:01 PM|
|mrbigjeep||the install is a snap. all you do is unbolt the old and bolt on the new.|
|11-29-2006 08:29 PM|
|Triple88a||i would say replace the swaybar links with aftermarket ones.. the stock are weak and will break again...|
|11-29-2006 06:44 PM|
Sway Bar Link?
Awhile back I had asked a question about a front end rattle, one piece of advice was that the front sway bar links are weak, or get weak. After desiphering what is what (thanks to this forum) I found the front sway bar links. When I grab them and give a little push pull back and forth I do get some movement. Does that mean they are shot, or on their way out? Do I need to replace them? Do I use stock, or aftermarket? This rig will not be doing alot of off roading at this time. If I do need to replace them, is the install as easy as taking the bolts off and reinstalling, or is there more to it?
I also noticed tonight and wanted to ask about the part directly below the bottom mount of the sway bar link on the passenger side, it looks like a steel plate that has a upper and lower bolt, well the lower bolt looks like it gets rubbed a little by the steering mechanism directly in front of it, I would guess on right hand turns. Is this something to be concerned about?
Thanks again for all of your help, Scooby