|03-09-2013 02:57 PM|
|03-08-2013 11:25 AM|
Good info here
teraflex does a full alignment on a Tj on YouTube.
3 part video. Here is part 1
Check out this video on YouTube:
|03-08-2013 10:59 AM|
|03-08-2013 10:56 AM|
Suspension Geometry - JeepForum.com
That's a good starter thread. Just read.
|03-08-2013 10:43 AM|
You're one of the most knowledgable people on this forum without a doubt. I've looked at the definitions of them before but it didn't really stick. Thanks for any help.
|03-08-2013 10:30 AM|
|03-08-2013 10:25 AM|
|03-08-2013 10:23 AM|
|03-08-2013 10:21 AM|
With my 3" lift, Currie LCAs set to 16" restored enough of my caster and also eliminated the annoying 47-53 mph shimmy.
|03-08-2013 10:20 AM|
|budke||Can't adjust the pinion angle too much though or you'll be burning through u-joints like theres no tomorrow.|
|03-08-2013 10:19 AM|
|03-08-2013 10:15 AM|
|Imped||Just visualize it.....lengthening the lowers will rotate the housing around the upper mount, moving the pinion down, lower ball joint forward and upper ball joint rearward....ie, increasing caster angle. By how much should you lengthen the arms? By the amount that puts your caster where you want it. The final length is a byproduct of caster.|
|03-08-2013 09:58 AM|
|PStov98TJ||Unlimited, I've been kicking around the idea of adj. CA's as well. So I was wondering, exactly how would you adjust the control arms? If I'm not mistaken you'd need to lengthen them right? And by how much? Thanks! Should help the OP too.|
|03-08-2013 07:50 AM|
|UnlimitedLJ04||you'll start by extending the lowers. you can also install uppers, but you likely will not adjust the uppers away from stock length.|
|03-08-2013 12:16 AM|
Adjustable Control Arms
I have a 3" Teraflex lift and I have no vibrations or DW... but my steering is too light compared to stock . I'm wanting to install adjustable front control arms to dial-in some caster and make my steering effort greater. Does it matter if I install upper versus lower control arms? The uppers seem to be a little cheaper, and I'd rather have threaded parts up & out of the way.