Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > JK Jeep Wrangler Forum > JK General Discussion Forum > Someone with 35"/3.5" setup help, please

Join Wrangler Forum Today

Thread: Someone with 35"/3.5" setup help, please Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
03-09-2013 04:55 PM
GoPacers If I replaced my current RC springs and replaced them with these, what would I gain? Metalcloak 3.5" Front Coil Spring, Dual-Rate, JK, Pair
03-09-2013 01:05 PM
RKracing I have been running Teraflex lifts for over 3 years on 4 Jeeps and no leaning on our 2 and 4 doors at all. I have friends with the same Teraflex lifts 2.5", 3", and 4" problems. But I do know 1 guy with a Pro Comp that has that problem and 1 other guy that has a .....not sure but it is a lower grade lift and it has a lean too. Maybe you can just buy new Teraflex coils or some other premium brand....they are worth it. Good Luck and let us know.
03-09-2013 12:55 PM
ljrubitm What you got going on is known as the JK lean. Over the years I have seen this on other forums and seen it in person. It's not only RC but other lift kits. People seem to think it's from the gas tank being on the passenger side that cause this to happen.
Over time any lift will settle a little.
03-09-2013 12:35 AM
Someone with 35"/3.5" setup help, please

I have an '07 4-door wrangler and had 35" tires and a 3.5" RC lift installed last April. Everything was great until this past month when I noticed the lift had lowered, with the passenger side being a tad lower than the drivers side. I had my Jeep looked at today and the mechanic said the lift kit was fine, that the coil springs had gone down from the weight. So I called RC today and the gentleman had me measure all 4 points from the middle of my tire to the bottom of the fender. He came back with "the passenger side is the correct height, that the driver side springs were wrong." He is going to ship me Two new springs for the drivers side to match the passenger side. Well, that's not what I wanted to hear, if anything the passenger side springs would be off because the driver side sits higher. I really enjoyed the look of the 3.5" lift when it was first put on, not knowing it would "settle" and I would lose about an inch.

If someone with this exact setup could measure different points on their jeep so I could compare would be greatly appreciated.

Thank you.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 02:32 AM.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC. is not in any way associated with the Chrysler Motors LLC