|03-23-2013 11:45 AM|
|kjeeper10||Hard to tell. Camber will be off on the alignment rack.|
|03-23-2013 11:33 AM|
|doclouie||Yea I would check the ball joints on that side. Most shops will do a alignment spec for free and give you a print out of what needs changed. Just on a side note I would rewind your winch cable if it still looks like that.|
|03-23-2013 11:31 AM|
|03-23-2013 11:28 AM|
Can you see in this photo how only the front right tire is off camber?
|03-23-2013 09:00 AM|
Too much toe in and the tires would look like this
Out \ /
So any wear would be both tires.
|03-23-2013 08:47 AM|
|03-23-2013 08:30 AM|
Any drivability issues ?
Never mind, he answered that. I have BF 35's and exhibit some of the same driving characteristics. Tires look ok but rotated sooner than normal.
The jeep does favor the left.
Balljoints are new. I am guessing a possible bent housing/ C knuckle,
|03-23-2013 07:18 AM|
If only one front tire is worn on the inside, then that wheel is running negative camber. If you were toed out then both front tires would be worn on the inside, but as you stated only one of yours is worn.
When going down the road does the steering pull some to the left?That would confirm negative camber on the right wheel. The Camber is none adjustable so I would say that you either have worn out ball joints allowing the tire to tip in at the top, or your axle housing is bent.
|03-23-2013 07:07 AM|
|SweetTeaDrinkerTJ98||Sounds like it needs aligned, your tire would be towed out. Check the balljoints.|
|03-23-2013 03:47 AM|
|PStov98TJ||Check the pressure in it as well. They should be running around 24-26 psi for on road usage.|
|03-23-2013 01:39 AM|
|calebjmcgowan||Can I simply replace one tire (the bay worn front right one) and align it, of should I do something more onto of that, as my jeep is really rough and is all over the road...|
|03-13-2013 09:26 PM|
|trav78||u should get ur alignment and ball joints checked .|
|03-13-2013 09:23 PM|
Tire Wear Problems
My front right tire on my 2001 TJ is worn really badly. I bought the Jeep used recently and it has BFG 35's on it, and the other three tires seem to be fine. What would cause that one tire to wear on the inside of the tire and how can it be fixed?