|04-12-2009 08:27 PM|
|04-12-2009 04:06 PM|
|bigshasta||so i have been around cars all my life and i have never heard of blinker fluid. what is that?|
|04-12-2009 03:49 PM|
Well, after pulling, cleaning and inspecting all of the pulleys, replacing the belt, and adding a Lucas ps additive, I still had the annoying squeal! I then pulled the fan and fan clutch off and installed the pulley on without the fan to determine whether the fan clutch was the problem...again no dice.
After putting everything back together I started the engine and while listening to the squeal, I pushed on the air box on top of the intake manifold and the squeal tone changed. It turned out that the intake manifold wasn't tight enough and air was being sucked between the manifold and the engine! Tightened it up and no more squeal!!!!
Thanks for everyones help.
|04-10-2009 03:27 PM|
Well, I removed the old belt, checked for any play in the pulleys and installed the new belt. After tightening everything up, I started the engine up and it started squealing again! The only thing else that I can think of is pulling the belt back off and spinning the alternator pulley and the power steering pulley to see if they spin freely....maybe one of them is on its way out?
Any other suggestions?
|04-07-2009 07:55 AM|
|nater344||I believe you are right gmarchant...I checked it last night and it seems a bit too loose (according to a friend of mine who is a mechanic). I'll have to manually adjust the tension, but I believe for piece of mind I will replace the belt first, then adjust the tension. Hopefully that will take care of the annoying squeal!|
|04-06-2009 03:46 PM|
|gmarchant||Your belt isn't tight enough.|
|04-06-2009 02:12 PM|
|BSing||A bar of soap rubbed against the fan belt while it is running will usually stop the noise for some time. (just be carefull to not take your hand off like holding the soap on it.) If it solves the problem put a new belt on. If it doesnt is something else.|
|04-06-2009 02:01 PM|
|nater344||I wouldn't mind a squeal at startup, but mine stays on for awhile until I give it gas and then it starts back up when I let off the gas and and push in the clutch to stop. I'll pull the belt off tonight and check it over for any cracks and check out if there is any play in any of the pulleys and/or the fan. I'll let you guys know how I make out. Thanks for the help.|
|04-06-2009 01:48 PM|
|Giancarlo||my belts has less than 1000 miles on it and i get a squeek on startup..|
|04-06-2009 01:30 PM|
|04-06-2009 01:29 PM|
|foxinthemudd||try tightening up your belt tensioner. I'm had the same problem with mine and it helped quell that problem.|
|04-06-2009 01:27 PM|
|Joshpfeffer||Without hearing the noise, it's tough for anyone to say, but even with the belt in good condition, it could still be squealing. Maybe some of that belt lube spray that they make would help? I have an '07 Caliber that I drive daily and the belt started squealing on me all of the time, so I sprayed that belt lube on there a couple times (the first application didn't stop it for good) and I haven't had a problem in months.|
|04-06-2009 01:20 PM|
|KBR97||could be alternator or water pump going bad also.|
|04-06-2009 01:14 PM|
|04-06-2009 01:08 PM|
I had the squealing too, replaced the belt, tensioner pulley, and the idler pulley all at the same time so I do not know which one was the exact problem, but it did fix the problem. The pulleys are pretty cheap, that is why I replaced them at the same time as the belt.
|04-06-2009 12:58 PM|
|nater344||Thanks 4Point...that is something a will check into....of course after I check the notorious "low blinker fluid indicator", flush the system and add "synthetic blinker fluid", while being careful not to trip the "headlight fluid relay".|
|04-06-2009 12:14 PM|
|4point||You could be losing a bearing on one of the accessories or the belt tensioner.|
|04-06-2009 12:11 PM|
|Giancarlo||no that will cause your headlight fluid relay to trip..|
|04-06-2009 12:08 PM|
|twinstackram||would it help to have synthetic blinker fluid??|
|04-06-2009 12:03 PM|
|Giancarlo||x2 on the blinker fluid.. its a notorious problem with the tjs|
|04-06-2009 10:49 AM|
|cavediverjc||It might be the "low blinker fluid" indicator......it emits a squealing to warn of low fluid. I'd check that first.|
|04-06-2009 10:25 AM|
|TeeJay||If it's not super loud it might be a vacuum leak. Those are usually described as more of a whistle though.|
|04-06-2009 10:11 AM|
|dos0711||Replace your fan belt and keep the old as a spare.|
|04-06-2009 09:30 AM|
Squealing Engine...Driving me crazy!
Recently my engine (upon startup) has been putting off a high pitched squeal. Originally the squeal was going away after the engine warmed up, but now it's squealing upon startup even when the engine is warm. The belt looks to be in good condition.....Any ideas would be appreciated.