Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > CJ Jeep Forum > CJ General Discussion Forum > Where do I start, need help! V8 experts please come too

Join Wrangler Forum Today


Thread: Where do I start, need help! V8 experts please come too Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
03-18-2013 04:51 PM
Wester101 Manual choke has helped mine
02-05-2013 09:37 AM
faultymechanics Yeah I figured it would be hard to check. Being stupid I just now asked the PO about the issue and he told me it is nothing to worry about. He said that he did it once before. Basically at that time the car had sat a month and he flooded the cylinder with gas and that bang and metal sound was it echoing through the headers. I think I am safe but I really really appreciate the help. If it still does it though and my dad swears he didn't flood it then I will take the steps you mentioned.

As a side note are there any things I can do to make it easier to start such an old engine in the cold?
02-05-2013 06:43 AM
Goofyjumper Pull the starter off and check it. Usually only two bolts holding it on and some electrical connections and then you can check for failure within it.

You may also want to check the fly wheel. Accessible via a small cover. You want to make sure all the teeth are still on the fly wheel.

There's not likely any harm in trying to start it again. If you starter is blown then that will be really obvious immediately as the engine wont turn over. If the fly wheel or starter teeth are damaged then you will here some grinding or just spinning when you go to start it.

If it is something more serious like a busted engine component.... well, the damage is already done and you will need to do more investigating.

It is really hard to diagnose the problem based on the details you gave, I kinda think you are on your own till you get to do some more investigating.

Good luck!
02-04-2013 09:05 PM
faultymechanics Help, any suggestions...I am afraid to try starting it again.
02-04-2013 08:07 AM
faultymechanics
Where do I start, need help! V8 experts please come too

So I have an 85' CJ7 with a chevy 327 and a holley 4 barrel. Usually it takes some pedal pumping and a turn to get her started in the cold. Right now I am up in VT and my dad has been turning it on once a week to keep her fresh but yesterday he had an issue. Usually it takes a couple tries to get her going my dad describes it as: "very hard" but who knows. The issue is yesterday after not being able to get it for a while he turned the key and it sounded like it was trying to start he heard a "metal on metal bang." Now obviously it is hard to know exactly what that is.

I know metal on metal is the worst sound when it comes to any kind of vehicle but I am hoping maybe the starter just went or something? I need help guys, oh he also said it wasn't a backfire.

Thanks, any help is appreciated, I don't know where to start and we are afraid to try starting it again.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 06:35 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC