Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ Tech Forum > Rear "POP" please help!

Join Wrangler Forum Today


Thread: Rear "POP" please help! Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
05-05-2013 09:58 AM
Islander10 Sounds like drive shaft joints, twisting in one direction when in reverse, then twisting in the other direction going forward.
How hard the pop would depend on how hard you press the stupid pedal. Lol
03-20-2013 10:42 AM
Duma Try this, park it in neutral on a smooth flat surface. Hand turn the rear left tire backward and forward- the Jeep only needs to move back and forth and inch or two. Watch the pinion angle very carefully. If you see the drive shaft/pinion move up and down at ALL (might only move a few millimeters) then the problem is either a loose control arm bolt or a worn bushing.

I had this happen last week on a 3 month old lift. Turned out a couple of the control arm bolts had loosened. Tightened them up and no more clunk. Suspension is quiet again. Good luck!
03-20-2013 09:13 AM
KingTJ I've been more attentive to it the last few days and notice that it doesn't happen everytime. It's only when I'm quick on the gas.. If I allow it to roll and build tension and THEN gas, it doesn't pop or clunk at all. I'm going to look into u joints, control arm bushings, and my sway bar before dropping the diff cover. Hoping its one of those things!!
03-19-2013 08:04 PM
BrandonsJeep mine had the terrible problem of a chipped ring gear... hte popping noise was the chipped off piece clanking around and screwing up the whole ring and pinion in the rear diff...);
03-19-2013 09:29 AM
Duma
Quote:
Originally Posted by jimmy_buckle View Post
To address the second 'pop noise' I had the same thing but it was when I was turning left. Took it to the mechanic for a service (I had just bought it) and he told me the rear sway bar was a little loose. Tightened it and good to go.

My experience
Agreed. Check your rear sway bar and all control arm bushings. You could just have a split CA bushing or a loose bolt that allows some play. Can make a clunk sound when stepping on the gas torques the axle.

If that isn't it, then start checking for loose/worn u-joints, pull the diff cover to check gears, etc.
03-19-2013 05:13 AM
jimmy_buckle To address the second 'pop noise' I had the same thing but it was when I was turning left. Took it to the mechanic for a service (I had just bought it) and he told me the rear sway bar was a little loose. Tightened it and good to go.

My experience
03-19-2013 12:59 AM
KingTJ What within the diff was wrong? I've seen a lot of people talk about how bad u joints can cause the same sound. Basically because when in the forward position the driveshaft is under tension and when switched to the reverse position the tension is released and the bad u joint experiences play and causes the pop or clunk. I'm not opposed to it being a problem within the diff but 1. I'd like to know what exactly was wrong with yours and 2. I'd like to find out how to mark other possible things off the list before ripping into the diff.
03-19-2013 12:39 AM
BrandonsJeep ohhhh man.... i just had this happen to mine, if you dont change it soon youll be a FWD jeeper.. its the rear diff, atleast it was in mine.. it wouldnt hurt to get it checked out before everything is screwed up!
03-18-2013 07:05 PM
KingTJ
Rear "POP" please help!

Hi all,
I own a 2000 auto with the dana 35 3.07 rear end. For a few months I've noticed a pop/clunk from the rear end after coming out of reverse and gassing. Not long ago had my pinion bearings replaced and while they had it apart they replaced inner and outer axle bearings and seals as well. Assumed that if there was something in the axles or diff causing the sound they would spot it but they told me everything besides the pinion bearings looked great. My question is, where do I begin to try and narrow the pop down? Ive also got a popping sound from the rear when making right hand turns. Don't believe it makes any sound turning left. Any advise would be appreciated.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 04:10 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC