|04-29-2013 02:53 PM|
Problem solved- The prick that sold me the the jeep cleared the codes before I bought it. Took it to the spealership and this is what was found.
1 bad 02 sensor bank 2/2, 2 bad cats-covered under the federal emissions warranty, evap line had a hole in it on top of the tank.
|04-16-2013 09:11 PM|
|bondosgto||Replace all O2's, use only oem/ntk/ngk, remove negative battery terminal for ten minutes. If you are having issues with one I guarantee you will have issues with more soon.|
|04-16-2013 08:04 PM|
I've had a couple of codes on my 2002 wrangler with the most resent being p0158. This code and the last(can remember which one) I was able to fix by just looking at the hoses by the air/whatever devices and each time found one that was split. The p0158 was a L shaped hose and I taped it and the error was gone in a few runs.
So, I always would start with looking for cracked and split rubber.
|03-21-2013 07:07 AM|
|03-21-2013 01:12 AM|
P0158 02 Sensor Circuit High Voltage (Bank 2 Sensor 2)
My first two quetions would be...
Have you done any offroading in water?
How many miles do you have on the Jeep?
|03-20-2013 10:15 PM|
|wwch99tj||Probably just needs replaced.|
|03-20-2013 08:40 PM|
02 sensor help p0158
I'm looking for some help here, and I'm sure this is posted somewhere on here but having a hard time finding it.I just bought my first jeep its an 06 wrangler x.The check engine light came on and i had followed the key sequence to display the OBD code p0158. I'm sure its a common issue but not sure how i should go about fixing it. Replacing the 02 sensor or is it the fuse/wiring.Any help is appreciated