Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > CJ Jeep Forum > CJ General Discussion Forum > New Tulsa Member-Need quick answer

Join Wrangler Forum Today

Thread: New Tulsa Member-Need quick answer Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
03-25-2013 10:54 PM
dry Thanks, we will see what happens......
03-25-2013 09:15 PM
Goofyjumper The simplest method.

Ground (large gauge) from battery to engine block.

Positive wire to ignition coil to provide spark.

Use heavy gauge positive from starter and strike onto positive of battery... (remove when started) If you have a starter coil then wiring it up would be a much better solution.

You are going to need to check the fuel and prime if needed. It's also wise to prime the oil system before starting a motor that's been sitting a long time. You can do this by removing the distributor and insert a priming tool to catch the oil pump shaft for rotating with a drill.
03-25-2013 06:26 PM
New Tulsa Member-Need quick answer

Nice site! Looking forward to being a member here! "Long Time Lurker"

Here is my question, I am going in the morning to look at a 76 CJ5 the wiring harness in the jeep is gone and the ignition column is jacked. The guy swears the engine was rebuilt and runs (LOL)

If I bring a hot battery and fuel or starting fluid what is the quickest way to by pass all the jacked up wiring and at least try to get it to start so I know the motor at least will try to start or even barely run.

can someone give me the procedure on a quick way to rewire the 304 engine to try to start it with a remote starting trigger from under the hood..........Any help would be much apreciated (Its a 76 Levi with a 304)

Thanking you in advance

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 07:25 PM.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC. is not in any way associated with the Chrysler Motors LLC