|04-16-2009 06:14 PM|
First, its 4" height will cause severe drivetrain vibrations installed as is without the purchase of a fairly expensive SYE (slip yoke eliminator) kit and longer aftermarket CV driveshaft to reduce the driveshaft's u-joint angles steepened excessively by that height. Plan on another $500 or so for those two items that will also need to be installed by someone not afraid to open up the transfer case.
You could kinda-sorta get away without the SYE and longer CV driveshaft if you dropped the transfer case skidplate an inch with a spacer kit and installed a set of 1" taller motor mounts but that's definitely a second-rate solution.
That kit also includes a dropped Pitman arm which with the kit configured as is, definitely should NOT be installed. Installing it is 100% guaranteed to cause bump steer which is where the steering is forced left/right when you drive over bumps/dips in the road. On a bad bump or dip, the steering wheel can literally be bumped right out of your hands, hence the term "bump steer". The only time a dropped Pitman arm should ever be installed onto a TJ is when also installing a dropped upper trackbar mount, or perhaps for 6" or taller lifts. Don't let anyone talk you into installing it, dropped Pitman arms that are required on older CJ and YJ Jeeps are bad news for TJs 99% of the time.
|04-16-2009 06:01 PM|
|04-16-2009 10:40 AM|
|MoA||heard the tera cas suck..|
|04-16-2009 07:38 AM|
I would also look at this one:
Rubicon Express - RE7002 3.5 Standard Kit FREE SHOCKS
includes shocks... will net around 4". I would also say you want to get a front adjustable track bar with either kit, vs the drop pitman arm. You also may need a SYE kit for the T-case, or might be able to get away with just the t-case drop at that lift height. Each jeep is a bit different...
|04-16-2009 07:23 AM|
Teraflex 4" Lift
TeraFlex 001141400 - TeraFlex Jeep TJ Suspension System Lift Kits
Anyone have any pros and cons I need to know about? If its reliable and what not?