|04-27-2013 06:17 PM|
|hooptieyj48||Whats that gonna do for power to the coil?|
|04-27-2013 05:30 PM|
turn the ignition on and try to start it at the solenoid. Use a button or bridge the two big posts with a flat head or jumper wire. Videos on youtube. Just be careful (neutral/E-brake)
If it is a safety swicth failure this will bypass it and the jeep will start. Either way if will help you narrow things down.
Did you check for codes?
|04-27-2013 04:02 PM|
|hooptieyj48||Well I try a new crank sensor and still nothing|
|03-31-2013 02:29 PM|
|hooptieyj48||I will give it a shot and see what happens|
|03-31-2013 02:13 PM|
Research CKS crankshaft position sensor, when it goes you'll get no power to coil. Don't get it confused with CPS camshaft position sensor, that is in the distrib.
There is a way to test the CKS, lots of info on the web about it. Pretty common problem on these old riggs. I have the 4.0 so I don't know where yours is located.
When mine went out my Jeep just died while driving then crank no start. It did not throw a code.
Have you looked for codes by turning the ignition on-off-on-off-on-off-on then wait for the CEL check engine light to flash. Have a pen ready to write the codes down. All the codes are two digit example Flash-flash-flash (pause) flash-flash-flash would be code 33. At the end of the codes it will flash a 55, that means End of codes.
If you need the codes let me know.
|03-31-2013 01:44 PM|
|hooptieyj48||It turns over fine it just has no power to the coil and its getting fuel|
|03-31-2013 01:31 PM|
|Squirrel 442||What are your symptoms? Example engine cranks but does not start. Or engine won't turn over when I turn the key.|
|03-31-2013 01:18 PM|
|hooptieyj48||I replaced the ignition switch its a manual and the fues and relays all seem to be working|
|03-31-2013 01:11 PM|
Need a little more detail in your post. There are many switches, relays and sensors on these old rigs.
Also need to know if it is an auto or manual trans. I just went through the no start problem on my 95 4.0.
|03-31-2013 12:58 PM|
I have a 93yj 2.5 I have no power to the coil I put a new switch in and still nothing