|04-02-2013 07:52 PM|
FYI, the yoke nut is supposed to be one time use only. I added some blue loctite when reinstalling mine.
Torque it to 180 ft.lbs
|04-02-2013 07:46 PM|
|04-02-2013 07:45 PM|
|rraa497||So I dont need any special tool to seat the seal?|
|04-02-2013 07:25 PM|
|SurfKaster||Not too bad. Easier with an impact wrench.|
|04-02-2013 07:08 PM|
|SCOOPYS-YJ||not hard to replace , need a 1 1/8" socket, mark the nut where it is tightened to, remove nut and yoke, pop seal, put new ones in and tighten nut to marks|
|04-01-2013 07:46 PM|
|Shark_13||Pinion seal, not too hard, cheap, plenty of diy websites to show you how. I did my diff fluid at same time.|
|04-01-2013 07:21 PM|
Leaking axle seals?
I was under the jeep and took some pictures of my axle seals front and rear (I believe). Are these hard to replace?