Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > JK Jeep Wrangler Forum > JK Pics Forum > Trail Cover Review

Join Wrangler Forum Today


Thread: Trail Cover Review Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-29-2009 10:52 PM
jcf Yep' true but I wouldn't care about dents & scratches on mine but would be pissed to have a cover rub the paint
04-28-2009 04:38 PM
nutmegger1957 JCF: valid point......and yet.....on the other hand.......if a Jeep is used as a trail rig, you're gonna get branch scratches, dents.......I guess it's all about what you want to use it for.
04-28-2009 01:33 PM
jcf Just want to mention something about covers, if it gets windy & the cover moves or flaps a little,be aware that it will rub your piant & can leave marks. Same applies to the car bra's that people put on their vehicles. Don't want to sound negative but it would be very dissapointing if you realised it was happening after it was too late
04-28-2009 04:35 AM
nutmegger1957 P.S.: I want to add one addendum, (if that's the right word) to my review of the Trail Cover, now that I've been using it all week.

There is a plastic tab near or about the corner of the back of the Trail Cover that never quite aligns with the vehicle. It seems to fall right were the turn is, on either back corner.

Since it is fairly stiff Polypro plastic, it doesn't conform to the corner and thus is rendered useless in snapping in place, up under the rear lips. The rear end has enough OTHER plastic snap ups along the side to hold it down, and the rear tailgate straps are sufficient for the back end.

If I were the Designer of this product, I'd put it through yet another iteration with the following changes:

A) Increase the material length that extends down over the windshield by 2 inches.
B) Allow more room (although it works "ok" now) for the collapsed soft top.
C) Replace the straight plastic snap up on the rear corners with a radius'd plastic snap
up or remove it altogether.
D) Remove the grommet option on the door flaps. Nobody uses em, and bees think
it's a "hive" entrance.

E)
04-25-2009 02:53 PM
AndyLA Good plan, man....... Jeep looks great and like I said....Nice review overall. Do what you got to do.... and you are doing that....
04-25-2009 12:05 PM
nutmegger1957 Yea, we have to fix the door and the opener........and get a dumpster to clean out the crap my wife has accumulated in there, but that's the ideal situation.
04-25-2009 07:14 AM
AndyLA Nice job on the actual write-up and review, but to me the product and the mismatched colors, just look strange. (No offense) --- I mean wouldn't it just be better to clean out and use that garage (if it is available) to protect your soft-top?
04-25-2009 05:37 AM
keg97 Nice review....thanks!
04-25-2009 05:25 AM
nutmegger1957
Trail Cover Review

Ok gang..........I told ya'll I was purchasing a BestTop Trail Cover for my 2008 JK 2-dr, and indeed I did.

It came in mid-week this week, but with all the rain we'd been having, it was not a great idea to try it out yet.

So Thursday night came, the rain was done, and Friday promised to be a great day, so I took the soft top down (not "off") and took the doors off, and threw on the Trail Cover before I went to bed.

As far as installation is concerned, it didn't take but a minute to figure out how to throw in over the top and which end was which. The straps-n-clips worked well, although I'd just give you a heads up that the adjuster tab on the straps may end up behind your running boards when you are tightening it down (and that's a little bit, not much, but a "little bit" of a hassle when you are loosening it to take it off, since you need to pull up on those adjusters to free the strap, and if it's behind the running board its a tad difficult to get to.........I ended up having to slide the clip a bit to manhandle the adjuster to a position where it could be released fully).

My biggest concern was how well the cover would fit over the soft top, (with the soft top in the down position), since I know that from day to day it may get rainy again and I didn't want to have to uninstall the soft top, and then re-install it, repeatedly), but the cover, (although snug on the back end) DID indeed fit over the collapsed soft top.

Color wise, who cares about the color (unless it only came in pink.......lol) but it happens to be gray. I guess they make other colors but only "gray" was available.

The plastic hold downs that fit into the rails along the sides and back worked fine, but I recommend putting the backside on first, and THEN the front. It goes a little easier for ya.

The front part of the Trail Cover that shows as being held down by the windshield wipers in the Quadratec magazine never really reaches that far down. It comes just to the top of the wipers. I thought I might try and stop my wipers in mid-cycle to allow a better opportunity for the wipers to act as a hold down for the front part of the Trail Cover, but this proved to be a mute point, since there is enough tension in the cover over all, to hold the front portion on to the windshield with no movement from wind or whatever. Sure was nice to have a clear windshield on Friday morning. There was little chill in the air that morning and my wife's Taurus had a bit of frost on her windshield. Mine..........Nada!!

Taking off the Trail Cover (other than the little bit of manipulation I had to do to get the strap release free because it was behind the running board), wasn't hard. The biggest thing I'd recommend with regard to removal is, be aware that it will be wet from the overnight, and your clothes will get a bit wet as you drape it over your shoulder to bring it to the garage. (By the way, I was asked by a friend of mine if it was hard to fold back up and put in the travel bag, and I'd just say that you don't want to fold up a wet cover. let it dry off before you fold it up......to avoid mildew).

Just as a friendly reminder, should you want to buy one of these from Quadratec.com...........they are selling it for $124.00, but JC Whitney sells it for $114.00 and Quadratec WILL "price match."

Ratings: (1= poor / 10 = Terrific)

Over all value of this top: 9
Ease of use: 9
Fit: 9
Cost - Value ratio: 10
Material: 10
Construction: 9
Effectiveness: 10
Worth the Purchase: 10

Here's a few pictures (note the Yellow Lab on the picnic table in the background of the last photo.....lol) of the top in place this morning, just the second time I've had it on: (I put it on in the dark last night when I got home from my monthly Bluegrass Jam, so I guess that means you could put it on with your eyes closed.....lol). Also note the "Jeepit.com side mirror that is mounted to the top hinge of the drivers side. The cover design leaves this mirror exposed.......no biggy, ....but just note the fact:









There are a couple of grommet holes on both door sides that allow you to put a security cable through the cover, to hold it on, but that's a bit unnecessary IMHO.

I hope this was helpful to ya'll..........

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 08:59 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC